MC68HC711E20CFN2 Freescale Semiconductor, MC68HC711E20CFN2 Datasheet - Page 289

• Manufacturer Part Number: MC68HC711E20CFN2
• Description: IC MCU 20K 2MHZ OTP 52-PLCC
• Manufacturer: Freescale Semiconductor
• Series: HC11r

Specifications of MC68HC711E20CFN2

• Core Processor: HC11
• Core Size: 8-Bit
• Speed: 2MHz
• Connectivity: SCI, SPI
• Peripherals: POR, WDT
• Number Of I /o: 38
• Program Memory Size: 20KB (20K x 8)
• Program Memory Type: OTP
• Eeprom Size: 512 x 8
• Ram Size: 768 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 52-PLCC
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

UPLOAD Utility
EPROM Programming Utility
AN1060 — Rev. 1.0
MOTOROLA
NOTE:
The UPLOAD utility subroutine transfers data from the MCU to a host
computer system over the SCI serial data link.
Only EPROM versions of the M68HC11 include this utility.
Verification of EPROM contents is one example of how the UPLOAD
utility could be used. Before calling this program, the Y index register is
loaded (by user firmware) with the address of the first data byte to be
uploaded. If a baud rate other than the current SCI baud rate is to be
used for the upload process, the user’s firmware must also write to the
baud register. The UPLOAD program sends successive bytes of data
out the SCI transmitter until a reset is issued (the upload loop is infinite).
For a complete commented listing example of the UPLOAD utility, refer
to
The EPROM programming utility is one way of programming data into
the internal EPROM of the MC68HC711E9 MCU. An external 12-V
programming power supply is required to program on-chip EPROM. The
simplest way to use this utility program is to bootload a 3-byte program
consisting of a single jump instruction to the start of the PROGRAM
utility program ($BF00). The bootloader program sets the X and Y index
registers to default values before jumping to the downloaded program
(see [16] at the bottom of
$FF character, data to be programmed into the EPROM is sent, starting
with the character for location $D000. After the last byte to be
programmed is sent to the MC68HC711E9 and the corresponding
verification data is returned to the host, the programming operation is
terminated by resetting the MCU.
The number of bytes to be programmed, the first address to be
programmed, and the programming time can be controlled by the user if
values other than the default values are desired.
Listing 3. MC68HC711E9 Bootloader
Figure
3). When the host computer sees the
ROM.
Application Note
289