MPC564MZP66 Freescale Semiconductor, MPC564MZP66 Datasheet - Page 220

• Manufacturer Part Number: MPC564MZP66
• Description: IC MCU 512K FLASH 66MHZ 388-BGA
• Manufacturer: Freescale Semiconductor
• Series: MPC5xxr

Specifications of MPC564MZP66

• Core Processor: PowerPC
• Core Size: 32-Bit
• Speed: 66MHz
• Connectivity: CAN, EBI/EMI, SCI, SPI, UART/USART
• Peripherals: POR, PWM, WDT
• Number Of I /o: 56
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 2.5 V ~ 2.7 V
• Data Converters: A/D 32x10b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 388-BGA
• For Use With: MPC564EVB - KIT EVAL FOR MPC561/562/563/564
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Burst Buffer Controller 2 Module
U-bus access mode of the RAM is activated by the BBCMCR[DCAE] bit setting (see
“BBC Module Configuration Register
the U-bus and cannot be accessed by the ICDU logic.
In this mode:
4.4.1.1
The DECRAM module does not acknowledge U-bus accesses that violate the configuration defined in the
BBCMCR. This causes the machine check exception for the internal RCPU or an error condition for the
MPC561/MPC563 external master.
4.4.1.2
The bus interface and DECRAM control logic are powered by V
by a separate power pin (IRAMSTBY).
4.5
The burst buffer controller contains a branch target buffer (BTB) to reduce the impact of branches on
processor performance. Following is a summary of the BTB features:
The BTB consists of eight branch target entries (BTE). Refer to
fully associative cache. Each entry contains a tag and several data buffers related to this tag.
4.5.1
When the RCPU generates a change of flow (COF) address for instruction fetch, the BTB control logic
compares it to the tag values currently stored in the tag register file where the following events can happen:
4-14
•
•
•
•
•
•
•
The DECRAM supports word, half-word and byte operations.
The DECRAM is emulated to be 32 bits wide. For example: a load access from offset 0 in the
DECRAM will deliver the concatenation of the first word in each of the DECRAM banks when
RAM 1 contains the 16 LSB of the word and RAM 2 contains the 16 MSB.
Load accesses at any width are supplied with 32 bits of valid data.
The DECRAM communicates with the U-bus pipeline but does not support pipelined accesses to
itself. If a store operation is second in the U-bus pipe, the store is carried out immediately and the
U-bus acknowledgment is performed when the previous transaction in the pipe completes.
Burst access is not supported.
Software controlled BTB enable/disable, inhibit, and invalidate
User transparent — no user management required
Branch Target Buffer
BTB Operation
Memory Protection Violations
DECRAM Standby Operation Mode
Instructions running from the DECRAM should not also perform store
operations to the DECRAM.
MPC561/MPC563 Reference Manual, Rev. 1.2
(BBCMCR)”). In this mode the DECRAM can be accessed from
NOTE
DD
Figure
supply. The memory array is supplied
4-5. All entries are managed as a
Freescale Semiconductor
Section 4.6.2.1,