MC68HC711K4CFN4 Freescale Semiconductor, MC68HC711K4CFN4 Datasheet - Page 168

• Manufacturer Part Number: MC68HC711K4CFN4
• Description: IC MCU 24K OTP 4MHZ 84-PLCC
• Manufacturer: Freescale Semiconductor
• Series: HC11r

Specifications of MC68HC711K4CFN4

• Core Processor: HC11
• Core Size: 8-Bit
• Speed: 4MHz
• Connectivity: SCI, SPI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 62
• Program Memory Size: 24KB (24K x 8)
• Program Memory Type: OTP
• Eeprom Size: 640 x 8
• Ram Size: 768 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 84-PLCC
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Serial Peripheral Interface (SPI)
8.3 SPI Functional Description
Technical Data
168
extra hardware. The SPI system can send data at up to one half of the
E-clock rate when configured as master and the full E-clock rate when
configured as a slave.
The SPI is a 4-wire, full-duplex communication system. Characters are
eight bits, transmitted most significant bit (MSB) first. One master device
exchanges data with one or more slave devices. Each device selects its
mode by writing either a 1 (master) or 0 (slave) to the MSTR bit in the
serial peripheral control register (SPCR). As a master device transmits
data to a slave device via the MOSI (master out slave in) line, the slave
transmits data to the master via the MISO (master in slave out) line. The
master produces a common synchronization clock signal and drives it on
its SCK (serial clock) pin, which is configured as an output. The slave
SCK pin is configured as an input to receive the clock. An external logic
low signal is applied to the slave select pin (SS) of each slave device for
which a particular message is intended. Devices not selected (SS high)
ignore the transmission.
Received characters are double-buffered. Serial input bits are fed into a
shift register; when the last bit is received, the completed character is
parallel-loaded to a read data buffer. This allows the next message to be
received while the current message is being read. As long as the buffer
is read before the next received character is ready to be transferred to
the buffer, no overrun condition occurs.
Transmitted characters are not double-buffered, they are written directly
to the output shift register. This means that new data for transmission
cannot be written to the shift register until the previous transmission is
complete. An attempt to write during data transmission will not go
through; the transmission in progress will proceed undisturbed, and the
MCU will set the write collision (WCOL) status bit in the serial peripheral
status register (SPSR). After the last bit of a character is shifted out, the
SPI transfer complete flag (SPIF) of the SPSR is set. This will also
generate an interrupt if the SPIE (SPI interrupt enable) bit in the SPCR
is set.
Freescale Semiconductor, Inc.
For More Information On This Product,
Serial Peripheral Interface (SPI)
Go to: www.freescale.com
M68HC11K Family
MOTOROLA