E3X-DA7 Omron, E3X-DA7 Datasheet - Page 24
![EXPANDABLE A/D NPN FO AMP](/photos/26/80/268071/e3xdasf_sml.jpg)
E3X-DA7
Manufacturer Part Number
E3X-DA7
Description
EXPANDABLE A/D NPN FO AMP
Manufacturer
Omron
Series
E3X-DA-Nr
Datasheet
1.E3X-DA6.pdf
(36 pages)
Specifications of E3X-DA7
Amplifier Type
Monitor Output
Voltage - Supply
12 V ~ 24 V
Output Type
NPN
Current - Supply
40mA
Mounting Type
*
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
Other names
E3XDA7
Optical Communications
Several Amplifiers can be slid together and used in groups.
Do not, however, slide the Amplifiers or attempt to remove any
of the Amplifiers during operation.
Hysteresis Adjustment
The hysteresis setting can be adjusted using the Mobile
Console. Do not, however, set the hysteresis to a value lower
than the factory setting. Using a setting less than the factory
setting may result in incorrect operation.
Amplifiers with Connectors
●
Mounting Connectors
(1) Insert the Master or Slave Connector into the Amplifier
(2) Join Amplifiers together as required after all the Master
(3) Attach the stickers (provided as accessories) to the sides
Note: Attach the stickers to the sides with grooves.
Removing Connectors
(1) Slide the slave Amplifier(s) for which the Connector is to
(2) After the Amplifier(s) has been separated, press down on
Mounting End Plate (PFP-M)
Depending on how it is mounted, an Amplifier may move
during operation. In this case, use an End Plate.
Before mounting an End Plate, remove the clip from the
master Amplifier using a nipper or similar tool.
Mounting
until it clicks into place.
and Slave Connectors have been inserted.
of Master and Slave Connectors that are not connected to
other Connectors.
be removed away from the rest of the group.
the lever on the Connector and remove it. (Do not attempt
to remove Connectors without separating them from other
Amplifiers first.)
http://www.ia.omron.com/
Sticker
Clip
Insert
Press down
Sticker
Remove
Lever
The clip can also be removed using the following mechanism,
which is incorporated in the construction of the section
underneath the clip.
(1) Insert the clip to be removed into the slit underneath the
(2) Remove the clip by rotating the Amplifier.
When using the E3X-DA-N with the Mobile Console, mount
the End Plate in the way shown below.
Pull Strengths for Connectors (Including Cables)
E3X-CN11, E3X-CN21, E3X-CN22: 30 N max.
E3X-CN12: 12 N max.
clip on another Amplifier.
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
Rotate
End Plate
E3X-DA-N
24