AMMP-6233-TR1G Avago Technologies US Inc., AMMP-6233-TR1G Datasheet - Page 5

• Manufacturer Part Number: AMMP-6233-TR1G
• Description: IC MMIC LNA 18GHZ-31GHZ 8SMD
• Manufacturer: Avago Technologies US Inc.

Specifications of AMMP-6233-TR1G

• Rf Type: VSAT, DBS
• Gain: 23.2dB
• Current - Supply: 65mA
• Frequency: 18GHz ~ 32GHz
• Noise Figure: 2.6dB
• P1db: 8dBm
• Package / Case: 8-SMD
• Test Frequency: 18GHz
• Voltage - Supply: 3 V ~ 5 V
• Frequency Rf: 32GHz
• Noise Figure Typ: 2.6dB
• Supply Current: 65mA
• Supply Voltage Range: 3V To 5V
• Frequency Max: 32GHz
• Termination Type: SMD
• Filter Terminals: SMD
• Rohs Compliant: Yes
• Frequency Min: 18GHz
• Number Of Channels: 1
• Frequency (max): 32GHz
• Power Supply Requirement: Single
• Single Supply Voltage (typ): 3V
• Single Supply Voltage (max): 5V
• Package Type: SMD
• Dual Supply Voltage (min): Not RequiredV
• Dual Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Pin Count: 8
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

AMMP-6233 Application and Usage
Figure 13. Application of AMMP-6233
Figure 14. Evaluation / Test Board (Available to qualified customer re-
quests)
Figure 15. Simplified LNA Schematic
RFin
In
AMMP-6233
1
7
Vdd
2
6
3
5
0.1uF
RFout
Vcc
Biasing and Operation
The AMMP-6233 is normally biased with a positive drain
supply connected to the VDD pin through a 0.1uF bypass
capacitor as shown in Figure 13. The recommended drain
supply voltage is 3V. It is important to have 0.1uF bypass
capacitor, and the capacitor should be placed as close to
the component as possible. Input and output ports are
DC-blocked. Impedance matching at input and output
ports are achieved on-chip, therefore, no extra external
component is needed. Aspects of the amplifier perfor-
mance may be improved over a narrower bandwidth by
application of additional conjugate, linearity, or low noise
(Γopt) matching No ground wires are needed because all
ground connections are made with plated through-holes
to the backside of the package.
Refer the Absolute Maximum Ratings table for allowed
DC and thermal condition
Out