ATA5724P3-TKQY Atmel, ATA5724P3-TKQY Datasheet - Page 16

• Manufacturer Part Number: ATA5724P3-TKQY
• Description: IC RCVR ASK/FSK UHF 20-SSOP
• Manufacturer: Atmel

Specifications of ATA5724P3-TKQY

• Frequency: 433MHz
• Sensitivity: -113dBm
• Data Rate - Maximum: 10 kbps
• Modulation Or Protocol: ASK, FSK
• Applications: General Purpose
• Current - Receiving: 11mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Voltage - Supply: 4.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 20-SOIC (0.200", 5.30mm Width)
• Operating Temperature (min): -40C
• Operating Temperature (max): 105C
• Operating Temperature Classification: Industrial
• Product Depth (mm): 4.4mm
• Operating Supply Voltage (min): 4.5V
• Operating Supply Voltage (typ): 5V
• Operating Supply Voltage (max): 5.5V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Memory Size: -
• Lead Free Status / Rohs Status: Compliant

8.6
Figure 8-7.
Figure 8-8.
16
Digital Signal Processing
Data_out (DATA)
Data_out (DATA)
ATA5723/ATA5724/ATA5728
Clock bit-check
counter
Dem_out
Synchronization of the Demodulator Output
Debouncing of the Demodulator Output
Dem_out
The data from the ASK/FSK demodulator (Dem_out) is digitally processed in different ways and
as a result converted into the output signal data. This processing depends on the selected
baud-rate range (BR_Range).
extended clock cycle T
state only after T
is always an integral multiple of T
The minimum time period between two edges of the data signal is limited to t
implies an efficient suppression of spikes at the DATA output. At the same time it limits the max-
imum frequency of edges at DATA. This eases the interrupt handling of a connected
microcontroller.
The maximum time period for DATA to stay low is limited to T
employed to ensure a finite response time in programming or switching off the receiver via pin
DATA. T
data stream.
receiver has switched to receiving mode.
T
t
XClk
DATA_min
DATA_L_max
Figure 8-9 on page 17
t
XClk
ee
is therefore longer than the maximum time period indicated by the transmitter
has elapsed. The edge-to-edge time period t
XClk
. This clock is also used for the bit-check counter. Data can change its
t
DATA_min
Figure 8-7
XClk
.
gives an example where Dem_out remains Low after the
t
ee
illustrates how Dem_out is synchronized by the
t
ee
ee
t
DATA_min
DATA_L_max
of the Data signal as a result
t
ee
ee
. This function is
T
9106E–RKE–07/08
DATA_min
. This