TDA5230 Infineon Technologies, TDA5230 Datasheet - Page 28

• Manufacturer Part Number: TDA5230
• Description: IC RECEIVER ASK/FSK 28-TSSOP
• Manufacturer: Infineon Technologies
• Type: Receiverr

Specifications of TDA5230

• Package / Case: 28-TSSOP
• Frequency: 433MHz ~ 450MHz, 865MHz ~ 868MHz
• Sensitivity: -111dBm
• Data Rate - Maximum: 20 kbps
• Modulation Or Protocol: ASK, FSK
• Applications: RKE, TPM, Security Systems
• Current - Receiving: 8mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Voltage - Supply: 3 V ~ 3.6 V, 4.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 105°C
• Operating Frequency: 870 MHz
• Operating Supply Voltage: 3.3 V, 5 V
• Maximum Operating Temperature: + 105 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Memory Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: SP000076520; TDA5230; TDA5230INTR

The crystal frequency is calculated:
Values for A depend on the frequency band: 302...320MHz...A=3 (TDA5231),
433...450MHz...A=2, 865...870MHz...A=1 (TDA5230)
The crystal frequency is automatically calculated by the IAF TDA523x
Configuration Tool.
Recommended Trimming Procedure
•
•
•
•
•
•
•
•
•
•
Using the High Precision Mode
As discussed earlier, the TDA523x allows to the crystal oscillator to be trimmed by the
use of internal trim capacitors. It is also possible to use the trim functionality to
compensate temperature drift of crystals.
During Run Mode (always when the receiver is active) the capacitors are automatically
connected and the oscillator is used in the High Precision Mode.
On entering Sleep Mode, the capacitors are automatically disconnected to save power.
If the High Precision Mode is also required for Sleep Mode, the automatic disconnection
of trim capacitors can be avoided by setting XALTREN to 1 (enable XTAL trim).
Setting of XALTREN has to be changed only in Run-Mode!
Data Sheet
For TDA5230 (Lo Side LO Injection)
For TDA5231 (Hi Side LO Injection
Set the TDA523x to SLEEP mode
Set the registers XTCAL0 and XTCAL1 to the expected nominal values
Set the TDA523x to Slave Mode Run
Set the register bit XTALTREN in register CMC1
Wait for 0.5ms minimum
Trim the oscillator by increasing and decreasing the values of XTALCAL0/1
Never change the trim capacitor size by more than 1 pF!
When the Oscillator is trimmed, reset the XALTREN bit
Set the TDA523x to SLEEP mode
Add the settings of XTCAL0/1 to the configuration. It must be set after every power
up or brown out!
f
f
sys
sys
=A*(f
=A*(f
RF
RF
+10.7MHz)/64
-10.7MHz)/64
24
Functional Description
Version 4.0, 2007-06-01
TDA523x