TDA5230 Infineon Technologies, TDA5230 Datasheet - Page 37

• Manufacturer Part Number: TDA5230
• Description: IC RECEIVER ASK/FSK 28-TSSOP
• Manufacturer: Infineon Technologies
• Type: Receiverr

Specifications of TDA5230

• Package / Case: 28-TSSOP
• Frequency: 433MHz ~ 450MHz, 865MHz ~ 868MHz
• Sensitivity: -111dBm
• Data Rate - Maximum: 20 kbps
• Modulation Or Protocol: ASK, FSK
• Applications: RKE, TPM, Security Systems
• Current - Receiving: 8mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Voltage - Supply: 3 V ~ 3.6 V, 4.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 105°C
• Operating Frequency: 870 MHz
• Operating Supply Voltage: 3.3 V, 5 V
• Maximum Operating Temperature: + 105 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Memory Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: SP000076520; TDA5230; TDA5230INTR

2.4.5
2.4.5.1
The Master Control Unit controls the operation modes, the global states, and is generally
responsible for automating data reception, verification, identification, extraction, and
storage into the FIFO. The data without RUNIN and TSI are read via SPI from the FIFO
by the external microcontroller.
The following operational modes and the behavior of the Master Control Unit are fully
automatic and influenced only by SFR settings and by incoming RF streams.
The TDA523x has two major operational modes. Modes are switched by the SFR bit
MSEL0
In Slave Mode the device is controlled via SPI by the external microcontroller. This mode
supports:
•
•
•
Switching between configurations and channels, as well as in between Run and Sleep
mode must be initiated by the microcontroller.
In Self Polling Mode TDA523x autonomously polls for incoming RF signals. The
receiver switches automatically between the two configurations (Configuration A and
Configuration B) and up to 3 channels per configuration (Further information is located
in
Between scans, the receiver is automatically switched off to save power. If an incoming
signal fulfills the selected wake-up criteria, matches the TSI pattern, and passes the
optional message ID screening, the payload is loaded into the FIFO, and, if not masked,
an interrupt is generated. Then, the payload data can be read via SPI.
Data Sheet
Chapter 2.4.6 Polling Timer
Run Mode Slave, where the receiver is continuously active
Sleep Mode, where the receiver is switched off for power saving. This mode can also
be used to change register settings
Hold Mode, allows to register settings to be changed. The change to Hold Mode and
back is faster than changing to Sleep Mode.
Master Control Unit
Overview
Unit).
33
Functional Description
Version 4.0, 2007-06-01
TDA523x