TORX177F,T Toshiba, TORX177F,T Datasheet - Page 4
![Fiber Optic Transmitters, Receivers, Transceivers TOSLINK Receiver Panel mount 15Mbps](/photos/15/67/156716/to147or177_sml.jpg)
TORX177F,T
Manufacturer Part Number
TORX177F,T
Description
Fiber Optic Transmitters, Receivers, Transceivers TOSLINK Receiver Panel mount 15Mbps
Manufacturer
Toshiba
Datasheet
1.TORX177FT.pdf
(5 pages)
Specifications of TORX177F,T
Function
Fiber optic receiving module for digital audio interface
Operating Voltage
5 V
Transmission Distance
5 m
Product
Receiver
Data Rate
0.1 Mbps to 15 Mbps
Wavelength
980 um to 1000 um
Pulse Width Distortion
15 ns
Maximum Output Current
5 mA
Operating Supply Voltage
4.75 V to 5.25 V
Maximum Operating Temperature
+ 70 C
Minimum Operating Temperature
- 20 C
Optical Fiber Type
RX
Data Transfer Rate
15Mbps
Operating Temperature Classification
Commercial
Operating Supply Voltage (min)
4.75V
Operating Supply Voltage (typ)
5V
Operating Supply Voltage (max)
5.25V
Operating Temp Range
-20C to 70C
Mounting
Snap in
Pin Count
3
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With
Digital Audio Optical Interface
(6)
(7)
(8)
(9)
(10) Interface
(11) Output
(12) Soldering condition
(13) Precautions when disposing of devices and packing materials.
(14) Precautions during use
Panel attachment
TORX177(F,T) has hole for panel attachment. Please be sure to attach it to panel with self−tapping
screw.
Solvent
Protective cap
When the TORX177(F,T) is not in use, attach the protective cap.
Supply voltage
Use the supply voltage within the recommended operating condition (V
that supply voltage does not exceed the maximum rating value of 6 V, even for an instant.
The TORX177(F,T) has a TTL interface. It can be interfaced with any TTL−compatible C−MOS IC.
If the receiver output is at low and is connected to the power supply, or if the output is high and is
connected to GND, the internal IC may be destroyed.
Solder at 260°C or less for no more than ten seconds.
When disposing devices and packing materials, follow the procedures stipulated by local regulations
in order to protect the environment against contamination.
Toshiba is continually working to improve the quality and the reliability of their products.
Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical
sensitivity and their vulnerability to physical stress. It is the responsibility of the buyer, when
utilizing Toshiba products, to observe standards of safety, and to avoid situations in which the
malfunction or failure of a Toshiba product could cause loss of human life, bodily injury or damage to
property.
When developing equipment, please ensure that Toshiba products are used within the specified
operating ranges set forth in the most recent product specifications. Also, please keep in mind the
precautions and conditions set forth in the Toshiba Semiconductor Reliability Handbook.
When using solvent for flux removal, do not use a high acid or high alkali solvent. Be careful not to
pour solvent in to the optical connector ports. If solvent is inadvertently poured in to them, clean it off
using cotton tips.
4
CC
= 5 ± 0.25 V). Make sure
TORX177(F,T)
2006-12-28