SX1231-31SKB915 Semtech, SX1231-31SKB915 Datasheet - Page 48

• Manufacturer Part Number: SX1231-31SKB915
• Description: TVS
• Manufacturer: Semtech

Specifications of SX1231-31SKB915

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

5.4.3. Rx Processing
If the bit synchronizer is disabled, the raw demodulator output is made directly available on DATA pin and no DCLK signal
is provided.
Conversely, if the bit synchronizer is enabled, synchronous cleaned data and clock are made available respectively on
DIO2/DATA and DIO1/DCLK pins. DATA is sampled on the rising edge of DCLK and updated on the falling edge as
illustrated below.
Note
5.5. Packet Mode
5.5.1. General Description
In Packet mode the NRZ data to (from) the (de)modulator is not directly accessed by the uC but stored in the FIFO and
accessed via the SPI interface.
In addition, the SX1231 packet handler performs several packet oriented tasks such as Preamble and Sync word
generation, CRC calculation/check, whitening/dewhitening of data, Manchester encoding/decoding, address filtering, AES
encryption/decryption, etc. This simplifies software and reduces uC overhead by performing these repetitive tasks within
the RF chip itself.
Another important feature is ability to fill and empty the FIFO in Sleep/Stdby mode, ensuring optimum power consumption
and adding more flexibility for the software.
Rev 3 - April 2010
ADVANCED COMMUNICATIONS & SENSING
DATA (NRZ)
DCLK
in Continuous mode it is always recommended to enable the bit synchronizer to clean the DATA signal even if the
DCLK signal is not used by the uC (bit synchronizer is automatically enabled in Packet mode).
Figure 29. Rx Processing in Continuous Mode
Page 48
DATASHEET
www.semtech.com
SX1231