TLE4998C4 Infineon Technologies, TLE4998C4 Datasheet - Page 32
![no-image](/images/manufacturer_photos/0/3/327/infineon_technologies_sml.jpg)
TLE4998C4
Manufacturer Part Number
TLE4998C4
Description
IC HALL SENSOR LINEAR SSO-4
Manufacturer
Infineon Technologies
Type
Linear - Programmabler
Datasheet
1.TLE4998C4.pdf
(42 pages)
Specifications of TLE4998C4
Sensing Range
-200mt Trip ~ 200mT Release
Voltage - Supply
4.5 V ~ 5.5 V
Current - Supply
8mA
Current - Output (max)
5mA
Output Type
Digital, PWM (Current)
Operating Temperature
-40°C ~ 150°C
Package / Case
4-SIP, SSO-4-01
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Features
-
Other names
SP000440972
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
12
The sensor supports a SPC (Short PWM Code) protocol, which enhances the
standardized SENT protocol (Single Edge Nibble Transmission) defined by SAE J2716.
SPC enables the use of enhanced protocol functionality due to the ability to select
between “synchronous”, “range selection” and “ID selection” protocol mode. The
following tables give an overview of relevant registers to chose the appropriate SPC
mode.
Table 17
Parameter
Protocol register
ID register
1)
Table 18
Mode
Synchronous
Dynamic range selection
ID selection
12.1
As in SENT, the time between two consecutive falling edges defines the value of a four
bit nibble, thus representing numbers between 0 and 15. The transmission time therefore
depends on the transmitted data values.The single edge is defined by a 3 unit time (UT)
low pulse on the output, followed by the high time defined in the protocol (nominal values,
may vary by tolerance of internal RC oscillator, not including analog delay of the open
drain output and influence by external circuitry, unit time programming see
Section
of the following parts, depicted in
• A trigger pulse by the master, which initiates the data transmission
• A synchronization period of 56 UT (in parallel, a new sample is calculated)
• A status nibble of 12-27 UT
• Between 3 and 6 data nibbles of 12-27 UT each (number is programmable, see
• A CRC nibble of 12-27 UT
• An end pulse to terminate the SPC transmission.
Data Sheet
The ID register is only actively used in ID selection mode.
Table
12.2). All values are multiples of a unit time frame concept. A transfer consists
20), representing the Hall value and temperature information
SPC Output Definition
Basic SPC Protocol Definition
SPC Mode Registers
SPC Mode Selection
Symbol Limit Values
P
ID
Parameter P
0
1
1
Figure
min. max.
11:
2
2
32
MSB
Unit
bit
bit
Parameter P
No effect
0
1
Notes
1)
SPC Output Definition
LSB
Explanation
Section 12.4
Section 12.5
Section 12.6
TLE4998C3C
Rev 1.1, 2009-09