R88A-CAU015S Omron, R88A-CAU015S Datasheet - Page 119
R88A-CAU015S
Manufacturer Part Number
R88A-CAU015S
Description
POWER CABLE 15M
Manufacturer
Omron
Datasheet
1.R88A-CAU001.pdf
(324 pages)
Specifications of R88A-CAU015S
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
- Current page: 119 of 324
- Download datasheet (3Mb)
Operation
Note U-UE-series (U-series, UE-type) and H-series Servomotors can only be used with Position Driver
Example: Procedure for Setting Code 1403
Note After setting the parameters, turn OFF the power and check to be sure that the displays have
If the display is normal (motor speed display) after the power is turned ON, rotate the motor shaft by
hand in both the forward and reverse directions and check to make sure that the positive and negative
signs in the display match the direction of rotation. If they do not match, check the encoder and resolver
cables to make sure they are connected correctly.
If an error message (A.L
and take the necessary countermeasures.
software version 4.01 (September 1997) or later. U-series 1 to 2-kW and M-series 1.1 to 2.2-kW
Servomotors can only be used with Position Driver software version 4.04 (April 1999) or later.
turned OFF before turning the power back ON again. (The values set for UP-02 will go into effect
when the power is turned back ON.)
Display
Parameter setting error (A.L 26) displayed. (The “.” in the rightmost digit flashes.)
Press the Mode Key twice to display the user parameters.
Press the Increment Key three times to display the contents of UP-02 (applicable
motor).
Press the Data Key and the Shift Key simultaneously to enable data to be
changed.
Press the Increment Key three times to enter “3” for the rightmost digit.
Press the Shift Key twice. The “100” digit (the third digit from the right) will flash.
Press the Increment Key four times to enter “4” for the “100” digit.
In the same way, press the Shift Key again so that the “1,000” digit (the leftmost
digit) flashes, and then press the Increment Key to enter “1” for that digit.
Finally, press the Data Key to set the data.
Forward rotation
) is displayed when the power is turned ON, refer to Chapter 4 Application
Reverse rotation
Display example
Key operation
Flashing
Forward rotation
Reverse rotation
Chapter 3
3-7
Related parts for R88A-CAU015S
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
G6S-2GLow Signal Relay
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Compact, Low-cost, SSR Switching 5 to 20 A
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet:
Part Number:
Description:
Manufacturer:
Omron Corporation
Datasheet: