BLM18AG102SN1 Murata, BLM18AG102SN1 Datasheet - Page 178

• Manufacturer Part Number: BLM18AG102SN1
• Manufacturer: Murata

Specifications of BLM18AG102SN1

• Mounting Style: Surface Mount
• Termination: Flat Style
• Operating Temp Range: -55C to 125C
• Current Rating (max): 0.4A
• Product Height (mm): 0.8mm
• Product Depth (mm): 0.8mm
• Product Length (mm): 1.6mm
• Lead Free Status / RoHS Status: Compliant

6
!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
1. Adhesive Tape Stress
This product is designed for using the adhesive tape to hold
itself to the object.
And please avoid causing mechanical stress by bending or
variation of the object.
2. Cleaning
Avoid cleaning product.
3. Handling of the product
Adhesive tape must be clean to maintain the quality of tape.
And please wipe off any dirt, dust and any kind of oil from
the surface of the object before use.
176
Microwave Absorbers Notice
Notice (Storage and Operating Conditions)
Product
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Flat cable
«Poor example»
Stress
Products shall be located in the sideways
direction to the mechanical stress.
«Good example»
4. Storage Conditions
(1) Storage period
(2) Storage conditions
Products which were inspected in Murata over 6 months
ago should be examined and used. This can be
confirmed with inspection No. marked on the container.
Adhesiveness should be checked if this period is
exceeded.
· Products should be stored in the warehouse on the
· Products should be stored in the warehouse without
following conditions.
heat shock, vibration, direct sunlight and so on.
Temperature: -10 to 40˚C
Humidity: 30 to 70% relative humidity
No rapid change on temperature and humidity
C31E.pdf
08.9.1