162GB16E1626PE714 Amphenol PCD, 162GB16E1626PE714 Datasheet - Page 33
![no-image](/images/manufacturer_photos/0/0/52/amphenol_pcd_sml.jpg)
162GB16E1626PE714
Manufacturer Part Number
162GB16E1626PE714
Description
Conn MIL-C-26482 Circular PIN 26 POS Crimp ST Cable Mount 26 Terminal 1 Port
Manufacturer
Amphenol PCD
Type
MIL-C-26482 Circularr
Datasheet
1.162GB10E1210PC416.pdf
(41 pages)
Specifications of 162GB16E1626PE714
Gender
PL
Termination Method
Crimp
Mounting
Cable Mount
Body Orientation
Straight
1.
2.
3.
4.
5.
6.
7.
8.
SHIELD TERMINATION CLAMPING PROCESS (Figures
4 through 8):
centre of Tool.
NOTE: To free Tool Handles, move Holding Clips to
Inspect Shield Termination.
Prepare Cable Braid for termination process (Figure 1)
Push Braid forward over Adapter Retention Lip to the
Adapter Incline Point (or .4” [10.2mm] minimum braid
length). Milk Braid as required to remove slack and
ensure a snug fit around the shield termination area
(Figure 2).
Prepare the Band in the following manner:
IMPORTANT: Due to Connector/ Adapter
circumference, it may be necessary to prepare the
Band around the Cable or Retention Area.
a) Roll Band through the Buckle Slot twice (Bands must
b) Pull on Band until Mark (¨È) is within approximately
NOTE: Prepared Band should have (¨È) Mark visible
approximately where shown in Figure 3.
Squeeze Gripper Release Lever and insert Band into the
front end opening of the Tool. (NOTE: Circular portion of
looped band must always be face downward).
Aligning the Band and Tool with the Shield Termination
Area, squeeze Black Pull-Up Handle repeatedly using
short strokes until it locks against the Tool Body. (This
indicates the Band is compressed to the Tool
Precalibrated Tension).
NOTE: If alignment of band and shield is
unsatisfactory, tension on band can be relaxed by
pushing on slotted release lever on top of tool. Make
adjustments as necessary and again squeeze black
pull-up handle.
Complete the Clamping Process by squeezing the Grey
Cut-Off Handle.
Remove excess Band from Tool.
be double-coiled).
(.250 inch (6.4mm) of Buckle Slot (Figure 3). The
Band may be tightened further if desired.
Interconnection Accessories
Adapter
SHIELD TERMINATION ASSEMBLY PROCESS
Adapter
Incline
Buckle
Retention Lip
Conductors
Indicator Mark
Tail Length
Braid
Termination area
Minimum Length
.400 (1.2mm)
Braid over
33