MOD-USB-RS232 Olimex Ltd., MOD-USB-RS232 Datasheet - Page 3

• Manufacturer Part Number: MOD-USB-RS232
• Description: Interface Modules & Development Tools USB TO RS232 INTERFACE MODULE
• Manufacturer: Olimex Ltd.

Specifications of MOD-USB-RS232

• Product: Interface Development Tools
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

BOARD USE REQUIREMENTS:
PROCESSOR FEATURES:
The MOD-MP3-X board is shipped in protective anti-static packaging. The board
must not be subject to high electrostatic potentials. General practice for working
with static sensitive devices should be applied when working with this board.
Cables: The cable you will need depends on the programmer/debugger you use. If
you use ARM-JTAG-EW, you will need USB A-B cable, for all types programmers
you will need ARM-JTAG-20to10 adapter.
Hardware: Programmer/Debugger
USB-TINY
programming/debugging tool. For EEPROM programming you can use
development programmer/debugger from Microchip, because we don't offer a
suitable programmer, yet.
MOD-MP3-X board use STM32F103RBT6 microcontroller from
STMicroelectronics with these features:
Core: ARM 32-bit Cortex™-M3 CPU
Memories
Clock, reset and supply management
Low power
72 MHz, 90 DMIPS with 1.25 DMIPS/MHz
Single-cycle multiplication and hardware division
Nested interrupt controller with 43 maskable interrupt channels
Interrupt processing (down to 6 CPU cycles) with tail chaining
128 Kbytes of Flash memory
20 Kbytes of SRAM
2.0 to 3.6 V application supply and I/Os
POR, PDR, and programmable voltage detector (PVD)
4-to-16 MHz quartz oscillator
Internal 8 MHz factory-trimmed RC
Internal 32 kHz RC
PLL for CPU clock
Dedicated 32 kHz oscillator for RTC with calibration
Sleep, Stop and Standby modes
VBAT supply for RTC and backup registers
,
ARM-USB-TINY-H
Page 3
ARM-JTAG-EW
, ARM-USB-OCD-H or other compatible
,
ARM-USB-OCD
PICkit 2
,
ARM-