LFE2M20E-6FN484C LATTICE SEMICONDUCTOR, LFE2M20E-6FN484C Datasheet - Page 12

• Manufacturer Part Number: LFE2M20E-6FN484C
• Description: FPGA LatticeECP2M Family 19000 Cells 90nm (CMOS) Technology 1.2V 484-Pin FBGA
• Manufacturer: LATTICE SEMICONDUCTOR

Specifications of LFE2M20E-6FN484C

• Package: 484FBGA
• Family Name: LatticeECP2M
• Device Logic Units: 19000
• Typical Operating Supply Voltage: 1.2 V
• Maximum Number Of User I/os: 304
• Ram Bits: 1246208

Lattice Semiconductor
Table 2-5. DLL Signals
DLLDELA Delay Block
Closely associated with each DLL is a DLLDELA block. This is a delay block consisting of a delay line with taps and
a selection scheme that selects one of the taps. The DCNTL[8:0] bus controls the delay of the CLKO signal. Typi-
cally this is the delay setting that the DLL uses to achieve phase alignment. This results in the delay providing a cal-
ibrated 90° phase shift that is useful in centering a clock in the middle of a data cycle for source synchronous data.
The CLKO signal feeds the edge clock network. Figure 2-7 shows the connections between the DLL block and the
DLLDELA delay block. For more information, please see the list of additional technical documentation at the end of
this data sheet.
Figure 2-7. DLLDELA Delay Block
PLL/DLL Cascading
LatticeECP2/M devices have been designed to allow certain combinations of PLL (GPLL and SPLL) and DLL cas-
cading. The allowable combinations are:
• PLL to PLL supported
• PLL to DLL supported
CLKI
CLKFB
RSTN
ALUHOLD
UDDCNTL
DCNTL[8:0]
CLKOP
CLKOS
LOCK
Signal
GDLLFB_PIO
CLKFB_CK
DLL_PIO
PLL_PIO
Routing
Routing
CLKOP
ECLK1
I/O
O
O
O
O
I
I
I
I
I
Clock input from external pin or routing
Active high freezes the ALU
Synchronous enable signal (hold high for two cycles) from routing
Encoded digital control signals for PIC INDEL and slave delay calibration
The primary clock output
The secondary clock output with fine phase shift and/or division by 2 or by 4
Active high phase lock indicator
DLL feed input from DLL output, clock net, routing or external pin
Active low synchronous reset
* Software selectable
*
*
*
CLKI
CLKFB
CLKI
DCNTL[8:0]
DLLDELA Delay Block
2-9
DLL Block
Description
LatticeECP2/M Family Data Sheet
CLKOP
CLKOS
LOCK
CLKO
Architecture