5962-8680502QA QP SEMICONDUCTOR, 5962-8680502QA Datasheet - Page 14

• Manufacturer Part Number: 5962-8680502QA
• Manufacturer: QP SEMICONDUCTOR

Specifications of 5962-8680502QA

• Lead Free Status / RoHS Status: Supplier Unconfirmed

DSCC FORM 2234
APR 97
(original equipment), design applications, and logistics purposes.
prepared specification or drawing.
the individual documents. This coordination will be accomplished using DD Form 1692, Engineering Change Proposal.
application requires configuration control and the applicable SMD. DSCC will maintain a record of users and this list will be
used for coordination and distribution of changes to the drawings. Users of drawings covering microelectronics devices (FSC
5962) should contact DSCC-VA, telephone [phone].
[phone].
103 have agreed to this drawing and a certificate of compliance (see 3.6 herein) has been submitted to and accepted by DSCC-
VA.
6. NOTES
6.1 Intended use. Microcircuits conforming to this drawing are intended for use for Government microcircuit applications
6.2 Replaceability. Microcircuits covered by this drawing will replace the same generic device covered by a contractor-
6.3 Configuration control of SMD's. All proposed changes to existing SMD's will be coordinated with the users of record for
6.4 Record of users. Military and industrial users shall inform Defense Supply Center Columbus (DSCC) when a system
6.5 Comments. Comments on this drawing should be directed to DSCC-VA, Columbus, Ohio 43218-3990, or telephone
6.6 Approved sources of supply. Approved sources of supply are listed in MIL-HDBK-103. The vendors listed in MIL-HDBK-
DEFENSE SUPPLY CENTER COLUMBUS
MICROCIRCUIT DRAWING
COLUMBUS, OHIO 43218-3990
STANDARD
1/ (*) indicates PDA applies to subgroups 1 and 7.
2/ (***) see 4.3.1c.
3/ Any subgroups at the same temperature may be combined when using a
4/ (**) indicates that subgroups 10 and 11, if not tested, shall be guaranteed to
5/ Subgroups 7, 8A, and 8B shall consist of verifying the applicable data pattern, see 4.3.1e.
Interim electrical parameters
Final electrical test parameters
Group A test requirements
Groups C and D end-point electrical
parameters (method 5005)
(method 5004)
(method 5004)
(method 5005)
multifunction tester.
the specified limits in table I.
MIL-STD-883 test requirements
TABLE II. Electrical test requirements.
5/
SIZE
A
Subgroups (in accordance with
table I)
MIL-STD-883, method 5005,
1/ 2/ 3/ 4/ 5/
1*, 2, 3, 7*,8A,8B,
1, 2, 3, 4***, 7,8A,
REVISION LEVEL
8B,9 10**, 11**
2, 3, 7,8A,8B
9, 10, 11
- - -
F
SHEET
5962-86805
14