STM32L-DISCOVERY STMicroelectronics, STM32L-DISCOVERY Datasheet - Page 25

• Manufacturer Part Number: STM32L-DISCOVERY
• Description: BOARD, EVAL, STM32L-DISCOVERY
• Manufacturer: STMicroelectronics
• Series: STM32r
• Type: MCUr

Specifications of STM32L-DISCOVERY

• Kit Contents: Board, Debugger, Programmer And Compiler
• Features: 128KB Flash Plus Multiple Timers, Analogue Peripherals
• Silicon Manufacturer: ST Micro
• Core Architecture: ARM
• Core Sub-architecture: Cortex - M3
• Silicon Core Number: STM32
• Silicon Family Name: STM32F1xx
• Rohs Compliant: Yes
• Contents: Board
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: STM32L
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

STM32F205xx, STM32F207xx
2.2.19
Note:
2.2.20
Note:
Low-power modes
The STM32F205xx and STM32F207xx support three low-power modes to achieve the best
compromise between low power consumption, short startup time and available wakeup
sources:
●
●
●
The RTC, the IWDG, and the corresponding clock sources are not stopped when the device
enters the Stop or Standby mode.
V
The V
external supercapacitor.
V
When the microcontroller is supplied from V
do not exit it from V
BAT
BAT
Sleep mode
In Sleep mode, only the CPU is stopped. All peripherals continue to operate and can
wake up the CPU when an interrupt/event occurs.
Stop mode
The Stop mode achieves the lowest power consumption while retaining the contents of
SRAM and registers. All clocks in the 1.2 V domain are stopped, the PLL, the HSI RC
and the HSE crystal oscillators are disabled. The voltage regulator can also be put
either in normal or in low-power mode.
The device can be woken up from the Stop mode by any of the EXTI line. The EXTI line
source can be one of the 16 external lines, the PVD output, the RTC alarm / wakeup /
tamper / time stamp events, the USB OTG FS/HS wakeup or the Ethernet wakeup.
Standby mode
The Standby mode is used to achieve the lowest power consumption. The internal
voltage regulator is switched off so that the entire 1.2 V domain is powered off. The
PLL, the HSI RC and the HSE crystal oscillators are also switched off. After entering
Standby mode, the SRAM and register contents are lost except for registers in the
backup domain and the backup SRAM when selected.
The device exits the Standby mode when an external reset (NRST pin), an IWDG reset,
a rising edge on the WKUP pin, or an RTC alarm / wakeup / tamper /time stamp event
occurs.
operation is activated when V
BAT
operation
pin allows to power the device V
BAT
operation.
Doc ID 15818 Rev 6
DD
is not present.
BAT
BAT
domain from an external battery or an
, external interrupts and RTC alarm/events
Description
25/163