1-215570-6 TE Connectivity, 1-215570-6 Datasheet - Page 15

• Manufacturer Part Number: 1-215570-6
• Description: MICRO-MATCH PBC.16P
• Manufacturer: TE Connectivity

Specifications of 1-215570-6

• Rohs Compliant: YES
• Product Type: Connector
• Type Of Connector: Paddleboard Connector
• Mount Angle: Vertical
• Pcb Mount Style: Through Hole
• Insulation Diameter (mm [in]): 0.90 [.035]
• Polarization: With
• Number Of Positions: 16
• Wire Range (mm [awg]): 0.08-0.09² [28]
• Centerline (mm [in]): 1.27 [0.050]
• Contact Base Material: Phosphor Bronze
• Contact Plating, Mating Area, Material: Tin
• Housing Color: Red
• Housing Material: Polyester GF
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Printed Circuit Board
• Packaging Method: Reel
• Packaging Quantity: 2,500

.
QUALITY ASSURANCE PROVISIONS
4.1
4.1.1
Samples shall be released in accordance with applicable instruction sheets. They shall be selected at
random from production. At least 5 connectors of the 6 positions or at least 30 contacts shall be used for
each testgroup.
4.1.2
Qualification inspection shall be verified by testing samples as specified in spec. 108-19052 Par 3.7.
4.2
If changes significantly affecting form, fit or function are made to the product or the manufacturing
process, product assurance shall co-ordinate requalification testing, consisting of all or part of the original
testing sequence as determined by development/product, quality and reliability engineering.
4.3
Acceptance is based on verification that the product meets the requirement of par 3.6. Failures attributed
to equipment, test set-up or operator deficiencies shall nor disqualify the product. When product failure
occurs, corrective action shall be taken and samples resubmitted to qualification. Testing to confirm
corrective action is required before submittal.
4.4
The applicable AMP quality inspection plan will specify the samples acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with applicable product drawing and this
specification.
Rev. F
R6-77 (Rev. 07-01)
Sample selection:
Test sequence
Qualification testing:
Requalification testing
Acceptance.
Quality Conformance Inspection
Page 15 of 15
108-19052