SPAKDSP303AG100 Freescale Semiconductor, SPAKDSP303AG100 Datasheet - Page 5

• Manufacturer Part Number: SPAKDSP303AG100
• Description: IC DSP 24BIT 100MHZ 144-LQFP
• Manufacturer: Freescale Semiconductor
• Series: DSP563xxr
• Type: Fixed Pointr

Specifications of SPAKDSP303AG100

• Interface: Host Interface, SSI, SCI
• Clock Rate: 100MHz
• Non-volatile Memory: ROM (576 B)
• On-chip Ram: 24kB
• Voltage - I/o: 3.30V
• Voltage - Core: 3.30V
• Operating Temperature: -40°C ~ 100°C
• Mounting Type: Surface Mount
• Package / Case: 144-LQFP
• Device Core Size: 24b
• Clock Freq (max): 100MHz
• Mips: 100
• Device Input Clock Speed: 100MHz
• Ram Size: 24KB
• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (min): 3V
• Operating Supply Voltage (max): 3.6V
• Operating Temp Range: -40C to 100C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 144
• Package Type: LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Signals/Connections
The DSP56303 input and output signals are organized into functional groups as shown in Table 1-1. Figure 1-1
diagrams the DSP56303 signals by functional group. The remainder of this chapter describes the signal pins in
each functional group.
Note: This chapter refers to a number of configuration registers used to select individual multiplexed signal
Freescale Semiconductor
Power (V
Ground (GND)
Clock
PLL
Address bus
Data bus
Bus control
Interrupt and mode control
Host interface (HI08)
Enhanced synchronous serial interface (ESSI)
Serial communication interface (SCI)
Timer
OnCE/JTAG Port
Notes:
functionality. Refer to the DSP56303 User’s Manual for details on these configuration registers.
CC
1.
2.
3.
4.
5.
)
Port A signals define the external memory interface port, including the external address bus, data bus, and control signals.
Port B signals are the HI08 port signals multiplexed with the GPIO signals.
Port C and D signals are the two ESSI port signals multiplexed with the GPIO signals.
Port E signals are the SCI port signals multiplexed with the GPIO signals.
There are 2 signal connections in the TQFP package and 7 signal connections in the MAP-BGA package that are not used.
These are designated as no connect (NC) in the package description (see Chapter 3).
Table 1-1.
Functional Group
DSP56303 Technical Data, Rev. 11
DSP56303 Functional Signal Groupings
Ports C and D
Port A
Port B
Port E
1
2
4
3
TQFP
Number of Signals
18
19
18
24
13
16
12
2
3
5
3
3
6
MAP-BGA
18
66
18
24
13
16
12
2
3
5
3
3
6
1
1-1