E2C-CR8A Omron, E2C-CR8A Datasheet - Page 11
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
E2C-CR8A
Manufacturer Part Number
E2C-CR8A
Description
Proximity Sensors SEP.AMP.PROX 3.MM 1.8mm DIST
Manufacturer
Omron
Series
E2Cr
Specifications of E2C-CR8A
Maximum Operating Temperature
+ 70 C
Sensing Distance
0.8 mm
Minimum Operating Temperature
- 25 C
Sensor Type
Inductive
Sensing Object
Metallic
Response Frequency
1kHz
Material - Body
Stainless Steel
Shielding
Shielded
Voltage - Supply
-
Output Type
-
Terminal Type
2-Wire
Package / Case
Cylinder
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
SRT1-P P P P P P P P D04S
Precautions
Refer to the CompoBus/S Operation Manual (W266) before using
the Terminal.
3 GENERAL SAFETY PRECAUTIONS
Sensor Amplifiers
Use only the Sensor Amplifier models listed in this data sheet
with the CompoBus/S Terminals.
E39-JID01 Terminal Block
Do not apply any voltage to the Terminal Block Unit. Power for
the sensor or switch wired to this terminal block is provided by
the CompoBus/S Terminal.
3 CONNECTING EXPANSION TERMINAL
1. Remove the cover from the side of the Communications Ter-
2. When the cover is removed, you can see the receptacle for
3. Insert the connector of Expansion Terminal into the Commu-
minal SRT1-TPD04S. (See Figure 1.)
the expansion connector inside.
nications Terminal’s receptacle. (See Figure 2.)
TO COMMUNICATIONS TERMINAL
Connector
Figure 1
Figure 2
Cover
3 ATTACHING AND REMOVING SENSOR
Attaching 1-Channel Amplifiers and Terminal Blocks
The following procedure shows how to install 1-channel Sensor
Amplifiers or Terminal Block in CompoBus/S Communications
and Expansion Terminals, models SRTP-TID04S and
SRTP-XID04S.
1. Hook Section A of the Amplifier or Terminal Block onto Sec-
2. Push in the Amplifier or Terminal Block until Section C locks
Removing 1-Channel Amplifiers and Terminal Blocks
1. While pushing Section D, pull the Amplifier or Terminal Block
2. When Section D releases from the lock, the Amplifier or
tion B of the CompoBus/S Terminal.
inside Section D of the CompoBus/S Terminal.
in direction E.
Terminal Block can be removed.
AMPLIFIERS
Section B
Section D
Section A
Push here
Section A
Bottom View
Section C
SRT1-P P P P P P P P D04S
Section D
11