ISP1161A1BM ST-Ericsson Inc, ISP1161A1BM Datasheet - Page 61

• Manufacturer Part Number: ISP1161A1BM
• Description: IC USB HOST/DEVICE CTRLR 64-LQFP
• Manufacturer: ST-Ericsson Inc

Specifications of ISP1161A1BM

• Controller Type: USB 2.0 Controller
• Interface: Parallel
• Voltage - Supply: 3.3V, 5V
• Current - Supply: 47mA
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 64-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 568-1163; ISP1161A1BM,557

Philips Semiconductors
9397 750 13961
Product data
Bit
Symbol
Reset
Access
R
7
0
Table 33:
Bit
31
30 to 18
17
16
15
14 to 2
1
0
R
6
0
HcRhStatus register: bit description
Symbol
CRWE
-
OCIC
LPSC
DRWE
-
OCI
LPS
R
5
0
Rev. 03 — 23 December 2004
reserved
Description
On write—ClearRemoteWakeupEnable: Writing a logic 1 clears
DeviceRemoveWakeupEnable. Writing a logic 0 has no effect.
reserved
OverCurrentIndicatorChange: This bit is set by hardware when a
change has occurred to the OCI field of this register. The HCD
clears this bit by writing a logic 1. Writing a logic 0 has no effect.
On read—LocalPowerStatusChange: The Root Hub does not
support the local power status feature. Therefore, this bit is always
read as logic 0.
On write—SetGlobalPower: In global power mode
(PowerSwitchingMode=0), this bit is written to logic 1 to turn on
power to all ports (clear PortPowerStatus). In per-port power
mode, it sets PortPowerStatus only on ports whose bit
PortPowerControlMask is not set. Writing a logic 0 has no effect.
On read—DeviceRemoteWakeupEnable: This bit enables the bit
ConnectStatusChange as a resume event, causing a state
transition USBSuspend to USBResume and setting the
ResumeDetected interrupt.
0 — ConnectStatusChange is not a remote wake-up event
1 — ConnectStatusChange is a remote wake-up event
On write—SetRemoteWakeupEnable: Writing a logic 1 sets
DeviceRemoveWakeupEnable. Writing a logic 0 has no effect.
reserved
OverCurrentIndicator: This bit reports overcurrent conditions
when global reporting is implemented. When set, an overcurrent
condition exists. When clear, all power operations are normal. If
per-port overcurrent protection is implemented this bit is always
logic 0.
On read—LocalPowerStatus: The Root Hub does not support the
local power status feature. Therefore, this bit is always read as
logic 0.
On write—ClearGlobalPower: In global power mode
(PowerSwitchingMode = 0), this bit is written to logic 1 to turn off
power to all ports (clear PortPowerStatus). In per-port power
mode, it clears PortPowerStatus only on ports whose
bit PortPowerControlMask is not set. Writing a logic 0 has no
effect.
R
4
0
USB single-chip host and device controller
R
3
0
R
2
0
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
ISP1161A1
OCI
R
1
0
LPS
R/W
60 of 136
0
0