ASI PROGRAMMER V2.0 ZMD, ASI PROGRAMMER V2.0 Datasheet - Page 8

• Manufacturer Part Number: ASI PROGRAMMER V2.0
• Description: PROGRAMMER, AS-INTERFACE
• Manufacturer: ZMD

Specifications of ASI PROGRAMMER V2.0

• Ic Product Type: Programmer
• Development Tool Type: Development Board
• Interface Type: CMOS, RS232
• Kit Features: ZMD's AS-Interface IC EEPROM, Open Serial Protocol Control, Integrated AS-I Power Generation
• Rohs Compliant: Yes

AS –Interface Programmer
User Manual
2.2.4
This module can change parameter data for each slave module bit by bit. After a network scan
parameter data can be set to the slave modules. The bits can be changed by setting (=”1”) a check
mark in the corresponding box. To send the parameter data to the slaves click on “Write Parameter” or
transfer this configuration to the input output control window to set parameters by click at “Write
Parameter” in the input output control window. Parameter data will be read back and will be shown by
red (=”0”) and green (=”1”) circles. A bold boarder at an input bit shows the sent parameter data in the
parameter window and in the corresponding input output control window.
With a click on “Load Parameter File” or “Save Parameter File” file the parameter settings can be
saved or loaded.
Rev. 1.08, Copyright © 2005, ZMD AG
All rights reserved. The material contained herein may not be reproduced, adapted, merged, translated, stored, or used without the prior written consent of the copyright
owner. The Information furnished in this publication is preliminary and subject to changes without notice.
bold boarder
parameter bit P1
is set to “1”
Activation of
4I4O mode
(spec 3.0)
Detected
Slave
5. The slave input data are shown by ed circles (=“0“) and green circles (=“1“). Output ports can
6. All outputs will be erased by a click on „Clear Outputs“.
7. A Click on „Change Address“ will open the slave addressing window.
Change parameter data
be changed by setting a check mark in the corresponding field.
loop counter
8/17