DC1297B Linear Technology, DC1297B Datasheet - Page 8

• Manufacturer Part Number: DC1297B
• Description: BOARD EVAL LTM4612
• Manufacturer: Linear Technology
• Series: µModuler

Specifications of DC1297B

• Design Resources: LTM4612 Spice Model LTM4612 Gerber Files DC1297B Design Files DC1297B Schematic
• Main Purpose: DC/DC, Step Down
• Outputs And Type: 1, Non-Isolated
• Power - Output: -
• Voltage - Output: 3.3V, 5V ,12V
• Current - Output: 5A
• Voltage - Input: 5 ~ 36 V
• Regulator Topology: Buck
• Frequency - Switching: 850kHz
• Board Type: Fully Populated
• Utilized Ic / Part: LTM4612
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

LTM4612
pin FuncTions
V
fier. Internally, this pin is connected to V
0.5% precision resistor. Different output voltages can be
programmed with an additional resistor between the V
and SGND pins. See the Applications Information section.
MARG0 (Pin C12): LSB Logic Input for the Margining
Function. Together with the MARG1 pin, the MARG0 pin
will determine if a margin high, margin low, or no margin
state is applied. The pin has an internal pull-down resistor
of 50k. See the Applications Information section.
MARG1 (Pins C11, D12): MSB Logic Input for the Margin-
ing Function. Together with the MARG0 pin, the MARG1 pin
will determine if a margin high, margin low, or no margin
state is applied. The pins have an internal pull-down resistor
of 50k. See the Applications Information section.
SGND (Pins D9, H12): Signal Ground Pins. These pins
connect to PGND at output capacitor point.
8
FB
(Pin F12): The Negative Input of the Error Ampli-
OUT
with a 100k
FB
COMP (Pins A11, D11): Current Control Threshold and
Error Amplifier Compensation Point. The current com-
parator threshold increases with this control voltage. The
voltage ranges from 0V to 2.4V with 0.7V corresponding
to zero sense voltage (zero current).
PGOOD (Pin G12): Output Voltage Power Good Indicator.
Open-drain logic output that is pulled to ground when the
output voltage is not within ±10% of the regulation point,
after a 25µs power bad mask timer expires.
RUN (Pins A10, B9): Run Control Pins. A voltage above
1.9V will turn on the module, and below 1V will turn off
the module. A programmable UVLO function can be ac-
complished with a resistor from V
a 5.1V zener to ground. Maximum pin voltage is 5V.
NC (Pins J12, K12, L12): No Connect Pins. Leave floating.
IN
to this pin that is has
4612fb