LCMXO2-1200HC-C-EVN Lattice, LCMXO2-1200HC-C-EVN Datasheet - Page 6

• Manufacturer Part Number: LCMXO2-1200HC-C-EVN
• Description: KIT DEVELOPMENT MACHX02 PLD
• Manufacturer: Lattice
• Series: MachXO2r
• Type: PLDr

Specifications of LCMXO2-1200HC-C-EVN

• Contents: Board, Cable, Documentation, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: LCMXO2-1200HC-MG132CR1
• Other names: 220-1169

Lattice Semiconductor
2. Download the ZIP file to your system and unzip it to a location on your PC.
Linux Support:
The USB interface drivers for the evaluation board are included in Linux kernel 2.4.20 or greater including distribu-
tions compatible with Lattice Diamond design software (Red Hat Enterprise v.3, v.4 or Novell SUSE Enterprise
v.10).
The Control SoC Demo is preprogrammed into the MachXO2 Control Evaluation Board, however over time it is
likely that your board will be modified.
To download the demo source files and reprogram the MachXO2 Control Evaluation Board:
1. Download demo application source code from www.latticesemi.com/mxo2-control-kit.
2. Use .\Demo_MachXO2_Control_SoC\project\control_soc_demo.jed to restore the MachXO2280 Control
3. Use .\Demo_PM_Control_BM\project\bm_demo.jed to restore the POWR1014A Board Management demo
Connecting to the MachXO2 Control Evaluation Board
1. Plug the AC-DC adopter to an outlet.
2. Power the board by inserting the AC-DC adopter into the power jack with reference designator J11. Once the
3. Connect the evaluation board to your PC using the USB cable provided. The USB connector in the board has
4. If you are prompted, “Windows may connect to Windows Update”, select No, not this time from available
5. Choose the Install from specific location (Advanced) option and click Next.
6. Select Search for the best driver in these locations and click the Browse button to browse to the Windows
7. Click Next. A screen will display as Windows copies the required driver files. Windows will display a message
Programming the PLDs
The three-pin header with reference designator J6 is used to select between the JTAG port of the MachXO2 or
POWR1014A device. Installing a jumper in pins 1 and 2 of J6 will select the JTAG port of the POWR1014A device.
Installing a jumper in pins 2 and 3 of J6 will select the JTAG port of the MachXO2 device.
Pin 1 of header J6 is marked on the silkscreen of the board with a white triangle as shown in Figure 4. This exam-
ple shows the jumper installed in pins 2 and 3 of the J6 header and the JTAG port of the MachXO2 device has been
selected.
Figure 4. J6 Header Used for Selecting the JTAG Port of the PLDs
SoC demo design.
design.
connection is made, a red LED with reference designator D12 will illuminate.
reference designator J5.
options and click Next to proceed with the installation.
driver folder created earlier. Select the CDM 2.04.06 WHQL Certified folder and click OK.
indicating that the installation was successful.
6
MachXO2 Control Development Kit
User’s Guide