TEA6101 NXP Semiconductors, TEA6101 Datasheet

no-image

TEA6101

Manufacturer Part Number
TEA6101
Description
Manufacturer
NXP Semiconductors
Datasheet

Specifications of TEA6101

Screening Level
Commercial
Lead Free Status / Rohs Status
Compliant

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
TEA6101T
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
TEA6101T
Manufacturer:
PHILIPS
Quantity:
19 067
Part Number:
TEA6101T/N
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
TEA6101T/N3
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
TEA6101T/N3
Manufacturer:
NXP
Quantity:
18 292
Objective specification
File under Integrated circuits, IC01
DATA SHEET
TEA6101/T
Antenna diversity circuit
INTEGRATED CIRCUITS
May 1992

Related parts for TEA6101

TEA6101 Summary of contents

Page 1

... DATA SHEET TEA6101/T Antenna diversity circuit Objective specification File under Integrated circuits, IC01 INTEGRATED CIRCUITS May 1992 ...

Page 2

... SOT163-1; 1996 September 10. May 1992 GENERAL DESCRIPTION Intended for multi-antenna FM car radio reception (antenna diversity system), the TEA6101/T selects the most favourable signal from one four antennae. Founded upon audible signal disturbance the criteria are derived from two signals: high frequency components (e.g. ...

Page 3

... FILTER (min) k VOLTAGE ADDER REFERENCE offset voltage LOW - PASS FILTER ADDER ADDER MONOSTABLE & & & MULTIVIBRATOR offset offset TIMING voltage 100 TEA6101T & reset test pin Fig.1 Block diagram. supply ground MEMORY LOAD OFFSET COMPARATOR STAGE to antenna JOHNSON 17 switch COUNTER 16 & ...

Page 4

... AUDOUT OUT3 16 5 LID OUT4 TEA6101T LIC 7 14 DSM LEAV 8 13 MODOUT NOAV V REF 9 12 TEST n.c. n. MBA542 - 1 Fig.2 Pin configuration (TEA6101T GND 2 17 CTRL OUT1 AUDIN 3 16 OUT2 AUDOUT 4 15 OUT3 LID 5 14 OUT4 TEA6101 LIC DSM LEAV 7 12 ...

Page 5

... A mute function should not precede the circuit. This function is therefore assumed by the TEA6101. When used in combination with the TEA6100 the 20 k input of the IF IC together with the 6 k output resistor of the TEA6101 cause an attenuation of 3 dB. The mute circuit therefore has 3 dB amplification of level voltages in excess of 2. Objective specifi ...

Page 6

... These modifications permit the behaviour of the antenna switch to be adapted to alternative IF amplifier IC's. PARAMETER PARAMETER 6 Objective specification TEA6101/T MIN. MAX. UNIT see Fig.3 30 ...

Page 7

... Philips Semiconductors Antenna diversity circuit DC CHARACTERISTICS Measurements using application circuit (Fig numbers in parenthesis refer to TEA6101T; all currents positive into the IC unless otherwise specified. SYMBOL PARAMETER positive supply voltage positive supply current P P total power dissipation tot V voltage at pin: pins May 1992 ...

Page 8

... THD 10 600 mV; 1 kHz; aud note 2; 300 Hz; 100 mV 2 off1 min ap with priority with no priority started with both 16 comparator outputs HIGH Objective specification TEA6101/T TYP. MAX. UNIT 20 k 19.3 V 2 455 mV 370 5.3 V +250 mV 1100 mV 348 ...

Page 9

... 2.0 handbook, halfpage P tot (W) 1.5 (1) 1.0 (2) 0 (1) SOT102 (2) SOT163A Fig.4 Derating curve. May 1992 CONDITIONS 0 + and C = 100 F the ripple rejection becomes 46 dB MBA540 - 1 125 175 o T amb ( C) 9 Objective specification TEA6101/T MIN. TYP. MAX. UNIT 0 1.6 3.5 V ...

Page 10

... REFERENCES JEDEC EIAJ ( 6.48 3.9 8.25 2.54 7.62 6.20 3.4 7.80 0.26 0.15 0.32 0.10 0.30 0.24 0.13 0.31 EUROPEAN PROJECTION Objective specification TEA6101/T SOT102-1 ( max. 9.5 0.254 0.85 8.3 0.37 0.01 0.033 0.33 ISSUE DATE 93-10-14 95-01-23 ...

Page 11

... REFERENCES JEDEC EIAJ MS-013AC detail 1.1 1.1 0.25 0.25 1.4 0.4 1.0 0.043 0.043 0.055 0.01 0.01 0.016 0.039 EUROPEAN PROJECTION Objective specification TEA6101/T SOT163 ( 0.9 0.1 0 0.035 0.004 0.016 ISSUE DATE 95-01-24 97-05-22 ...

Page 12

... Use only a low voltage soldering iron (less than 24 V) applied to the flat part of the lead. Contact time must be limited to 10 seconds 300 C. When using a dedicated tool, all other leads can be soldered in one operation within seconds between 270 and 320 C. 12 Objective specification TEA6101/T ...

Page 13

... These products are not designed for use in life support appliances, devices, or systems where malfunction of these products can reasonably be expected to result in personal injury. Philips customers using or selling these products for use in such applications their own risk and agree to fully indemnify Philips for any damages resulting from such improper use or sale. May 1992 13 Objective specification TEA6101/T ...

Related keywords