SI3019-F-FT Silicon Laboratories Inc, SI3019-F-FT Datasheet - Page 60

• Manufacturer Part Number: SI3019-F-FT
• Description: IC VOICE DAA GCI/PCM/SPI 16TSSOP
• Manufacturer: Silicon Laboratories Inc
• Type: Chipsetr

Specifications of SI3019-F-FT

• Package / Case: 16-TSSOP
• Function: Data Access Arrangement (DAA)
• Interface: GCI, PCM, SPI
• Number Of Circuits: 1
• Voltage - Supply: 3 V ~ 3.6 V
• Current - Supply: 8.5mA
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Includes: Line Voltage Monitor, Loop Current Monitor, Overload Detection, Parallel Handset Detection, Polarity Reversal Detection, TIP and
• Product: Modem Chip
• Supply Voltage (min): 3 V
• Supply Current: 8.5 mA
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power (watts): -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Si3050
Register 1. Control 1
Reset settings = 0000_0000
60
Bit
5:4
7
6
3
2
1
0
Name
Type
Bit
PWMM[1:0] Pulse Width Modulation Mode.
Reserved Read returns zero.
Reserved Read returns zero.
Reserved Read returns zero.
PWME
Name
IDL
SR
R/W
SR
D7
Software Reset.
0 = Enables the DAA for normal operation.
1 = Sets all registers to their reset value.
Note: Bit automatically clears after being set.
Used to select the type of signal output on the call progress AOUT pin.
00 = PWM output is clocked at 16.384 MHz as a delta-sigma data stream. A local density of
1s and 0s tracks the combined transmit and receive signals. Use this setting with the optional
call progress circuit shown in Figure 18 on page 19.
01 = Balanced conventional PWM output signal has high and low portions of the modulated
pulse that are centered on the 16 kHz sample clock.
10 = Conventional PWM output signal returns to logic 0 at regular 32 kHz intervals and rises
at a time in the 32 kHz period proportional to its instantaneous amplitude.
11 = Reserved.
Pulse Width Modulation Enable.
0 = Pulse width modulation mode disabled (AOUT).
1 = Enable pulse width modulation mode for the call progress analog output (AOUT). This
mode sums the transmit and receive audio paths and presents this as a CMOS digital-level
output of PWM data. The circuit in Figure 18 on page 19 should be used.
Isolation Digital Loopback.
0 = Digital loopback across the isolation barrier is disabled.
1 = Enables digital loopback mode across the isolation barrier. The line-side device must be
enabled and off-hook prior to setting this mode. The data path includes the TX and RX filters.
D6
D5
PWMM[1:0]
R/W
Rev. 1.2
D4
Function
PWME
R/W
D3
D2
R/W
IDL
D1
D0