ATmega1284RZAP Atmel Corporation, ATmega1284RZAP Datasheet - Page 33

• Manufacturer Part Number: ATmega1284RZAP
• Manufacturer: Atmel Corporation

Specifications of ATmega1284RZAP

• Flash (kbytes): 128 Kbytes
• Max. Operating Frequency: 20 MHz
• Max I/o Pins: 32
• Spi: 3
• Twi (i2c): 1
• Uart: 2
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Crypto Engine: No
• Sram (kbytes): 16
• Eeprom (bytes): 4096
• Operating Voltage (vcc): 1.8 to 3.6
• Timers: 3
• Frequency Band: 2.4 GHz
• Max Data Rate (mb/s): 0.25
• Antenna Diversity: No
• External Pa Control: No
• Power Output (dbm): 3
• Receiver Sensitivity (dbm): -101
• Receive Current Consumption (ma): 16.0
• Transmit Current Consumption (ma): 17.0
• Link Budget (dbm): 104

8059D–AVR–11/09
where:
Ce - is optional external capacitors as described in
Ci - is is the pin capacitance in
CL - is the load capacitance for a 32.768 kHz crystal specified by the crystal vendor.
C
Crystals specifying load capacitance (CL) higher than the ones given in the
32, require external capacitors applied as described in
Figure 7-3.
Table 7-9.
Crystals specifying load capacitance (CL) higher than 8.0 pF, require external capacitors applied
as described in
To find suitable load capacitance for a 32.768 kHz crysal, please consult the crystal datasheet.
When this oscillator is selected, start-up times are determined by the SUT Fuses and CKSEL0
as shown in
Table 7-10.
Note:
Power Conditions
BOD enabled
Fast rising power
Slowly rising power
BOD enabled
Fast rising power
Slowly rising power
S
- is the total stray capacitance for one TOSC pin.
1. These options should only be used if frequency stability at start-up is not important for the
application.
Min. (pF)
Table
TBD
Crystal Oscillator Connections
Low-frequency Crystal Oscillator Internal load Capacitance
Start-up Times for the Low Frequency Crystal Oscillator Clock Selection
Figure 7-2 on page
7-10.
Start-up Time from
Power-down and
Table 7-8 on page 32
Reserved
Reserved
Power-save
32K CK
32K CK
32K CK
1K CK
1K CK
1K CK
29.
Typ. (pF)
8.0
Figure 7-2 on page 29
TOSC2
TOSC1
Additional Delay
14CK + 4.1 ms
14CK + 65 ms
Figure 7-2 on page
14CK + 4.1 ms
14CK + 65 ms
(V
from Reset
CC
14CK
14CK
= 5.0V)
(1)
(1)
(1)
ATmega1284P
29.
CKSEL0
Max. (pF)
Table 7-8 on page
TBD
0
0
0
0
1
1
1
1
SUT1..0
00
01
10
11
00
01
10
11
33