SAM3S1A Atmel Corporation, SAM3S1A Datasheet - Page 803

• Manufacturer Part Number: SAM3S1A
• Manufacturer: Atmel Corporation

Specifications of SAM3S1A

• Flash (kbytes): 64 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 64 MHz
• Cpu: Cortex-M3
• # Of Touch Channels: 17
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 34
• Ext Interrupts: 34
• Usb Transceiver: 1
• Quadrature Decoder Channels: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 2
• Twi (i2c): 2
• Uart: 3
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 12
• Adc Speed (ksps): 1000
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

Figure 35-7. Command/Response Functional Flow Diagram
Note:
6500C–ATARM–8-Feb-11
1. If the command is SEND_OP_COND, the CRC error flag is always present (refer to R3 response in the High Speed MultiMe-
dia Card specification).
The following flowchart shows how to send a command to the card and read the response if
needed. In this example, the status register bits are polled but setting the appropriate bits in the
interrupt enable register (HSMCI_IER) allows using an interrupt method.
Check error bits in the
Wait for command
status register
ready status flag
(1)
HSMCI_ARGR = Argument
Set the command argument
HSMCI_CMDR = Command
Read response if required
Does the command involve
Status error flags?
Set the command
Read HSMCI_SR
Read HSMCI_SR
a busy indication?
RETURN OK
NOTBUSY
CMDRDY
1
1
(1)
RETURN ERROR
Yes
No
0
0
RETURN OK
(1)
SAM3S
803