SAM3S1B Atmel Corporation, SAM3S1B Datasheet - Page 849

• Manufacturer Part Number: SAM3S1B
• Manufacturer: Atmel Corporation

Specifications of SAM3S1B

• Flash (kbytes): 64 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 64 MHz
• Cpu: Cortex-M3
• # Of Touch Channels: 23
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 34
• Ext Interrupts: 34
• Usb Transceiver: 1
• Quadrature Decoder Channels: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 3
• Twi (i2c): 2
• Uart: 4
• Ssc: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 10
• Adc Resolution (bits): 12
• Adc Speed (ksps): 1000
• Analog Comparators: 1
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

6500C–ATARM–8-Feb-11
The PWM master clock (MCK) is divided in the clock generator module to provide different
clocks available for all channels. Each channel can independently select one of the divided
clocks.
The clock generator is divided in three blocks:
Each linear divider can independently divide one of the clocks of the modulo n counter. The
selection of the clock to be divided is made according to the PREA (PREB) field of the PWM
Clock register (PWM_CLK). The resulting clock clkA (clkB) is the clock selected divided by DIVA
(DIVB) field value.
After a reset of the PWM controller, DIVA (DIVB) and PREA (PREB) are set to 0. This implies
that after reset clkA (clkB) are turned off.
At reset, all clocks provided by the modulo n counter are turned off except clock ”MCK”. This sit-
uation is also true when the PWM master clock is turned off through the Power Management
Controller.
CAUTION:
• Before using the PWM macrocell, the programmer must first enable the PWM clock in the
Power Management Controller (PMC).
– a modulo n counter which provides 11 clocks: F
– two linear dividers (1, 1/2, 1/3, ... 1/255) that provide two separate clocks: clkA and
F
clkB
MCK
/16, F
MCK
/32, F
MCK
/64, F
MCK
/128, F
MCK
/256, F
MCK
MCK
, F
MCK
/512, F
/2, F
MCK
MCK
/1024
/4, F
MCK
/8,
SAM3S
849