SAM3S1B Atmel Corporation, SAM3S1B Datasheet - Page 98

• Manufacturer Part Number: SAM3S1B
• Manufacturer: Atmel Corporation

Specifications of SAM3S1B

• Flash (kbytes): 64 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 64 MHz
• Cpu: Cortex-M3
• # Of Touch Channels: 23
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 34
• Ext Interrupts: 34
• Usb Transceiver: 1
• Quadrature Decoder Channels: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 3
• Twi (i2c): 2
• Uart: 4
• Ssc: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 10
• Adc Resolution (bits): 12
• Adc Speed (ksps): 1000
• Analog Comparators: 1
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

10.12.6.3
10.12.6.4
10.12.6.5
10.12.6.6
98
LDM
STMDB
STM
LDM
SAM3S
Restrictions
Condition flags
Examples
Incorrect examples
R8,{R0,R2,R9}
R1!,{R3-R6,R11,R12}
R5!,{R5,R4,R9} ; Value stored for R5 is unpredictable
R2, {}
The accesses happen in order of decreasing register numbers, with the highest numbered regis-
ter using the highest memory address and the lowest number register using the lowest memory
address. If the writeback suffix is specified, the value of Rn - 4 * (n-1) is written back to Rn.
The PUSH and POP instructions can be expressed in this form. See
99
In these instructions:
When PC is in reglist in an LDM instruction:
These instructions do not change the flags.
• Rn must not be PC
• reglist must not contain SP
• in any STM instruction, reglist must not contain PC
• in any LDM instruction, reglist must not contain PC if it contains LR
• reglist must not contain Rn if you specify the writeback suffix.
• bit[0] of the value loaded to the PC must be 1 for correct execution, and a branch occurs to
• if the instruction is conditional, it must be the last instruction in the IT block.
for details.
this halfword-aligned address
; There must be at least one register in the list
; LDMIA is a synonym for LDM
“PUSH and POP” on page
6500C–ATARM–8-Feb-11