SAM3S4B Atmel Corporation, SAM3S4B Datasheet - Page 148

• Manufacturer Part Number: SAM3S4B
• Manufacturer: Atmel Corporation

Specifications of SAM3S4B

• Flash (kbytes): 256 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 64 MHz
• Cpu: Cortex-M3
• # Of Touch Channels: 23
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 79
• Ext Interrupts: 79
• Usb Transceiver: 1
• Quadrature Decoder Channels: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 3
• Twi (i2c): 2
• Uart: 4
• Ssc: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 10
• Adc Resolution (bits): 12
• Adc Speed (ksps): 1000
• Analog Comparators: 1
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 48
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

10.18.11 WFE
10.18.11.1
10.18.11.2
10.18.11.3
10.18.11.4
148
WFE
SAM3S
Syntax
Operation
Condition flags
Examples
; Wait for event
Wait For Event.
where:
cond
WFE is a hint instruction.
If the event register is 0, WFE suspends execution until one of the following events occurs:
If the event register is 1, WFE clears it to 0 and returns immediately.
For more information see
This instruction does not change the flags.
• an exception, unless masked by the exception mask registers or the current priority level
• an exception enters the Pending state, if SEVONPEND in the System Control Register is set
• a Debug Entry request, if Debug is enabled
• an event signaled by a peripheral or another processor in a multiprocessor system using the
SEV instruction.
WFE{cond}
is an optional condition code, see
“Power management” on page
“Conditional execution” on page
73.
6500C–ATARM–8-Feb-11
84.