SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 119

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Figure 14-8. Watchdog Reset
14.4.6
11053B–ATARM–22-Sep-11
11053B–ATARM–22-Sep-11
WDRPROC = 0
Reset State Priorities
Only if
periph_nreset
proc_nreset
The Reset State Manager manages the following priorities between the different reset sources,
given in descending order:
Particular cases are listed below:
(nrst_out)
• Backup Reset
• Wake-up Reset
• User Reset
• Watchdog Reset
• Software Reset
• When in User Reset:
• When in Software Reset:
• When in Watchdog Reset:
RSTTYP
wd_fault
NRST
SLCK
MCK
– A watchdog event is impossible because the Watchdog Timer is being reset by the
– A software reset is impossible, since the processor reset is being activated.
– A watchdog event has priority over the current state.
– The NRST has no effect.
– The processor reset is active and so a Software Reset cannot be programmed.
– A User Reset cannot be entered.
proc_nreset signal.
Freq.
Any
Any
Processor Startup
= 3 cycles
XXX
EXTERNAL RESET LENGTH
8 cycles (ERSTL=2)
0x2 = Watchdog Reset
SAM9G35
SAM9G35
119
119