SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 409

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

29.13 Slow Clock Mode
29.13.1
Figure 29-31. Read/write Cycles in Slow Clock Mode
11053B–ATARM–22-Sep-11
11053B–ATARM–22-Sep-11
NBS0, NBS1,
NBS2, NBS3,
A0,A1
Slow Clock Mode Waveforms
A[25:2]
NWE
MCK
NCS
SLOW CLOCK MODE WRITE
The SMC is able to automatically apply a set of “slow clock mode” read/write waveforms when
an internal signal driven by the Power Management Controller is asserted because MCK has
been turned to a very slow clock rate (typically 32kHz clock rate). In this mode, the user-pro-
grammed waveforms are ignored and the slow clock mode waveforms are applied. This mode is
provided so as to avoid reprogramming the User Interface with appropriate waveforms at very
slow clock rate. When activated, the slow mode is active on all chip selects.
Figure 29-31
chip selects.
1
Table 29-5.
Read Parameters
NRD_SETUP
NRD_PULSE
NCS_RD_SETUP
NCS_RD_PULSE
NRD_CYCLE
NWE_CYCLE = 3
1
Table 29-5
illustrates the read and write operations in slow clock mode. They are valid on all
Read and Write Timing Parameters in Slow Clock Mode
1
indicates the value of read and write parameters in slow clock mode.
Duration (cycles)
0
2
1
1
2
NBS0, NBS1,
NBS2, NBS3,
A0,A1
Write Parameters
NWE_SETUP
NWE_PULSE
NCS_WR_SETUP
NCS_WR_PULSE
NWE_CYCLE
A[25:2]
MCK
NRD
NCS
SLOW CLOCK MODE READ
NRD_CYCLE = 2
1
Duration (cycles)
1
SAM9G35
SAM9G35
1
1
0
3
3
409
409