SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 479

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Figure 31-4. Picture-In-Picture Mode Support
11053B–ATARM–22-Sep-11
11053B–ATARM–22-Sep-11
an interrupt to signal the completion of the DMAC transfer. You can then re-program the channel
for a new DMAC transfer.
Single-buffer DMAC transfer: Consists of a single buffer.
Multi-buffer DMAC transfer: A DMAC transfer may consist of multiple DMAC buffers. Multi-buf-
fer DMAC transfers are supported through buffer chaining (linked list pointers), auto-reloading of
channel registers, and contiguous buffers. The source and destination can independently select
which method to use.
Picture-in-Picture Mode: DMAC contains a picture-in-picture mode support. When this mode is
enabled, addresses are automatically incremented by a programmable value when the DMAC
channel transfer count reaches a user defined boundary.
Figure 31-4 on page 479
i m a g e _ b a s e _ a d d r e s s i n m e m o r y . A u s e r d e f i n e d s t a r t a d d r e s s i s d e f i n e d a t
Picture_start_address. The incremented value is set to memory_hole_size = image_width -
picture_width, and the boundary is set to picture_width.
Channel locking: Software can program a channel to keep the AHB master interface by locking
the arbitration for the master bus interface for the duration of a DMAC transfer, buffer, or chunk.
– Linked lists (buffer chaining) – A descriptor pointer (DSCR) points to the location
– Replay – The DMAC automatically reloads the channel registers at the end of each
– Contiguous buffers – Where the address of the next buffer is selected to be a
in system memory where the next linked list item (LLI) exists. The LLI is a set of
registers that describe the next buffer (buffer descriptor) and a descriptor pointer
register. The DMAC fetches the LLI at the beginning of every buffer when buffer
chaining is enabled.
buffers to the value when the channel was first enabled.
continuation from the end of the previous buffer.
illustrates a memory mapped image 4:2:2 encoded located at
SAM9G35
SAM9G35
479
479