SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 851

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

Figure 39-45. Master Node Configuration, NACT = PUBLISH
11053B–ATARM–22-Sep-11
11053B–ATARM–22-Sep-11
TXRDY
RXRDY
US_LINIR
US_THR
LINTC
Write
Write
Break
Header
Synch
• Case 2: NACT = SUBSCRIBE, the USART receives the response
• Case 3: NACT = IGNORE, the USART is not concerned by the response
– If all the data have not been written, redo the two previous steps
– Wait until LINTC in US_CSR rises
– Check the LIN errors
– Wait until RXRDY in US_CSR rises
– Read RCHR in US_RHR
– If all the data have not been read, redo the two previous steps
– Wait until LINTC in US_CSR rises
– Check the LIN errors
– Wait until LINTC in US_CSR rises
– Check the LIN errors
Data 1
Protected
Identifier
Data3
Frame slot = TFrame_Maximum
Response
space
Data 2
Frame
Data 1
Data 3
Data N
Response
Data N-1
Data N
Checksum
SAM9G35
SAM9G35
FSDIS=1
space
frame
Inter-
FSDIS=0
851
851