SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 933

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

41.7.11
11053B–ATARM–22-Sep-11
Write Protection Registers
To prevent any single software error that may corrupt ADC behavior, certain address spaces
can be write-protected by setting the WPEN bit in the
(ADC_WPMR).
If a write access to the protected registers is detected, then the WPVS flag in the ADC Write Pro-
tect Status Register (ADC_WPSR) is set and the field WPVSRC indicates in which register the
write access has been attempted.
The WPVS flag is reset by writing the ADC Write Protect Mode Register (ADC_WPMR) with the
appropriate access key, WPKEY.
The protected registers are:
•
•
•
•
•
•
•
•
•
•
“ADC Mode Register” on page 937
“ADC Channel Sequence 1 Register” on page 939
“ADC Channel Sequence 2 Register” on page 940
“ADC Channel Enable Register” on page 941
“ADC Channel Disable Register” on page 942
“ADC Extended Mode Register” on page 951
“ADC Compare Window Register” on page 952
“ADC Analog Control Register” on page 954
“ADC Touchscreen Mode Register” on page 955
“ADC Trigger Register” on page 960
“ADC Write Protect Mode Register”
SAM9G35
933