ATmega88PA Automotive Atmel Corporation, ATmega88PA Automotive Datasheet - Page 170

• Manufacturer Part Number: ATmega88PA Automotive
• Manufacturer: Atmel Corporation

Table 21-11. Serial Programming Instruction Set (Continued)
Notes:
Figure 21-2. Serial Programming Instruction example
170
Instruction/Operation
Write Fuse bits
Write Fuse High bits
Write Extended Fuse Bits
Byte 1
1. Not all instructions are applicable for all parts.
2. adr = address
3. Bits are programmed ‘0’, unprogrammed ‘1’.
4. To ensure future compatibility, unused Fuses and Lock bits should be unprogrammed (‘1’).
5. Refer to the corresponding section for Fuse and Lock bits, Calibration and Signature bytes and Page size.
6. Instructions accessing program memory use a word address. This address may be random within the page range.
7. See http://www.atmel.com/avr for Application Notes regarding programming and programmers.
Atmel ATtiny24/44/84 [Preliminary]
Load Program Memory Page (High/Low Byte)/
Load EEPROM Memory Page (page access)
Bit 15 B
Byte 2
Adr M M S S B
A
(1)
If the LSB in RDY/BSY data byte out is ‘1’, a programming operation is still pending. Wait until
this bit returns ‘0’ before the next instruction is carried out.
Within the same page, the low data byte must be loaded prior to the high data byte.
After data are loaded to the page buffer, program the EEPROM page (see
page
Byte 3
170.
Adr LSB
Page Offset
0
Serial Programming Instruction
Byte 4
Byte 1
$AC
$AC
$AC
Program Memory/
EEPROM Memory
Page Buffer
Page N-1
Page 0
Page 1
Page 2
Byte 1
Byte 2
$A0
$A8
$A4
Instruction Format
Page Number
Bit 15 B
Byte 2
Write Program Memory Page/
Write EEPROM Memory Page
Adr MSB
Byte 3
$00
$00
$00
Byte 3
A A dr r L L SB B
0
Figure 21-2 on
data byte in
data byte in
data byte in
7701E–AVR–02/11
Byte4
Byte 4