STM32F100C6 STMicroelectronics, STM32F100C6 Datasheet - Page 21

• Manufacturer Part Number: STM32F100C6
• Description: Mainstream Value line, ARM Cortex-M3 MCU with 32 Kbytes Flash, 24 MHz CPU, motor control and CEC functions
• Manufacturer: STMicroelectronics

Specifications of STM32F100C6

• Peripherals Supported: timers, ADC, SPIs, I2Cs, USARTs and DACs
• Conversion Range: 0 to 3.6 V
• 16-bit, 6-channel Advanced-control Timer: up to 6 channels for PWM output, dead time generation and emergency stop
• Systick Timer: 24-bit downcounter

STM32F100x4, STM32F100x6, STM32F100x8, STM32F100xB
2.2.23
2.2.24
2.2.25
DAC (digital-to-analog converter)
The two 12-bit buffered DAC channels can be used to convert two digital signals into two
analog voltage signal outputs. The chosen design structure is composed of integrated
resistor strings and an amplifier in noninverting configuration.
This dual digital Interface supports the following features:
●
●
●
●
●
●
●
●
●
●
Eight DAC trigger inputs are used in the STM32F100xx. The DAC channels are triggered
through the timer update outputs that are also connected to different DMA channels.
Temperature sensor
The temperature sensor has to generate a voltage that varies linearly with temperature. The
conversion range is between 2 V < V
connected to the ADC1_IN16 input channel which is used to convert the sensor output
voltage into a digital value.
Serial wire JTAG debug port (SWJ-DP)
The ARM SWJ-DP Interface is embedded, and is a combined JTAG and serial wire debug
port that enables either a serial wire debug or a JTAG probe to be connected to the target.
The JTAG TMS and TCK pins are shared respectively with SWDIO and SWCLK and a
specific sequence on the TMS pin is used to switch between JTAG-DP and SW-DP.
two DAC converters: one for each output channel
up to 10-bit output
left or right data alignment in 12-bit mode
synchronized update capability
noise-wave generation
triangular-wave generation
dual DAC channels’ independent or simultaneous conversions
DMA capability for each channel
external triggers for conversion
input voltage reference V
REF+
Doc ID 16455 Rev 6
DDA
< 3.6 V. The temperature sensor is internally
Description
21/87