DS2430A Maxim, DS2430A Datasheet - Page 9

no-image

DS2430A

Manufacturer Part Number
DS2430A
Description
The DS2430A 256-bit 1-Wire® EEPROM identifies and stores relevant information about the product to which it is associated
Manufacturer
Maxim
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
DS2430A
Manufacturer:
DALLAS
Quantity:
80
Part Number:
DS2430A
Manufacturer:
DALLAS
Quantity:
5 510
Part Number:
DS2430A+
Manufacturer:
MAXIM
Quantity:
4 000
Part Number:
DS2430AP
Manufacturer:
MAX
Quantity:
20 000
Part Number:
DS2430AP+T
Manufacturer:
NEC
Quantity:
1 680
Part Number:
DS2430AP+T&R
Manufacturer:
Maxim
Quantity:
20 000
Part Number:
DS2430AP+T&R
Manufacturer:
MAXIM
Quantity:
10 000
Part Number:
DS2430AP+T&R
0
Part Number:
DS2430AX-SP
Manufacturer:
GRAYHILL
Quantity:
500
1-WIRE BUS SYSTEM
The 1-Wire bus is a system that has a single bus master and one or more slaves. In all instances, the
DS2430A is a slave device. The bus master is typically a microcontroller. The discussion of this bus
system is broken down into three topics: hardware configuration, transaction sequence, and 1-Wire
signaling (signal type and timing). The 1-Wire protocol defines bus transactions in terms of the bus state
during specified time slots that are initiated on the falling edge of sync pulses from the bus master.
Hardware Configuration
The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to
drive it at the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open
drain connection or three-state outputs. The 1-Wire port of the DS2430A is open drain with an internal
circuit equivalent to that shown in Figure 7. A multidrop bus consists of a 1-Wire bus with multiple
slaves attached. The DS2430A communicates at regular 1-Wire speed, 15.3kbits per second, and requires
a pullup resistor as shown in Figure 7. The idle state for the 1-Wire bus is high. If for any reason a
transaction needs to be suspended, the bus MUST be left in the idle state if the transaction is to resume. If
this does not occur and the bus is left low for more than 120µs, one or more of the devices on the bus may
be reset.
HARDWARE CONFIGURATION Figure 7
Note: Depending on the 1-Wire communication speed and the bus characteristics, the optimal pullup
resistor value will be in the 0.3kΩ to 2.2kΩ range. To write to a single device, a R
V
V
scratchpad to EEPROM.
PUP
PUP
, the resistor should be bypassed by a low-impedance pullup to V
of at least 4.0V is sufficient. For writing multiple DS2430As simultaneously or operation at low
9 of 19
R
R
PU
PU
I
L
PUP
while the device copies the
PUPmax
resistor and
DS2430A

Related parts for DS2430A