TMPM382FSFG Toshiba, TMPM382FSFG Datasheet - Page 564

• Manufacturer Part Number: TMPM382FSFG
• Manufacturer: Toshiba

Specifications of TMPM382FSFG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 64K
• Rom Type: Flash
• Ram (kbytes): 8K
• Number Of Pins: 64
• Package: QFP(14x14)
• Vcc: 5V
• Cpu Mhz: 40
• Ssp (ch) Spi: 1
• I2c/sio (ch): 1
• Uart/sio (ch): 3
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 10
• 16-bit Timer / Counter: 6
• Motor / Igbt Control: Y
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: -
• Comparators: -
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit

Single chip mode
Single boot mode
23.2 Operation Mode
Operation mode
Normal mode
User boot mode
Among the flash memory operation modes listed in the above table, the User Boot mode and the
Single Boot mode are the programmable modes. These two modes, the User Boot mode and the
Single Boot mode, are referred to as "Onboard Programming" modes where onboard rewriting of
internal flash memory can be made on the user's card.
This device has three operation modes including the mode not to use the internal flash memory.
After reset is cleared, it starts up from the internal flash memory.
In this operation mode, two different modes, i.e., the mode to execute user application programs and the
mode to rewrite the flash memory onboard the user’s card, are defined. The former is referred to as
"normal mode" and the latter "user boot mode.
The user can uniquely configure the system to switch between these two modes.
For example, the user can freely design the system such that the normal mode is selected when the port
"A0" is set to "1" and the user boot mode is selected when it is set to "0."
The user should prepare a routine as part of the application program to make the decision on the
selection of the modes.
After reset is cleared, it starts up from the internal Boot ROM (Mask ROM). In the Boot ROM, an
algorithm to enable flash memory rewriting on the user’s set through the serial port of this device is
programmed. By connecting to an external host computer through the serial port, the internal flash
memory can be programmed by transferring data in accordance with predefined protocols.
TMPM380/M382 - 3 / 54 -
Table 23-1 Operation Modes
Operation details
TMPM380/M382