TMPM382FSFG Toshiba, TMPM382FSFG Datasheet - Page 74

• Manufacturer Part Number: TMPM382FSFG
• Manufacturer: Toshiba

Specifications of TMPM382FSFG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 64K
• Rom Type: Flash
• Ram (kbytes): 8K
• Number Of Pins: 64
• Package: QFP(14x14)
• Vcc: 5V
• Cpu Mhz: 40
• Ssp (ch) Spi: 1
• I2c/sio (ch): 1
• Uart/sio (ch): 3
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 10
• 16-bit Timer / Counter: 6
• Motor / Igbt Control: Y
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: -
• Comparators: -
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit

(3) Preconfiguration 1 (Interrupt from external pin)
(4) Preconfiguration 2 (interrupt from peripheral IP)
(5) Configuring the clock generator
used as the function pin. Setting PnIE[m] allows the pin to be used as the input port.
CGIMCG register of the clock generator. The CGIMCG registers are the registers for configuring each
factor.
unexpected interrupt. To clear corresponding interrupt request, write value corresponding to the interrupt
to be used to the CGICRCG register. See 7.6.3.6 CG Interrupt Request Clear Register for each value.
as the standby clearing factor. However, inputting the “H” pulse or the signal in “H” level is required so that
the CPU can detect it as an interrupt factor.
Set “1” to the port function register of the corresponding pin. Setting PnFRx[m] allows the pin to be
The setting varies depending on the IP to be used. See chapters of relevant IP for details.
For an interrupt to clear the standby mode, configure active level and enabling interrupt by the
Before enabling an interrupt, clear the corresponding interrupt request already held. This can avoid
An interrupt from the external pin can be used without setting the clock generator if it does not function
(Note)
(Note)
● Port register
PnFRx<PnmFRx>
PnIE<PnmIE>
●Clock generator register
CGIMCGn<EMCGm>
CGICRCG<ICRCG>
CGIMCGn<INTmEN>
n: port number
m: corresponding bit
x: function register number
n: register number
m: number assigned to each interrupt factor
TMPM380/M382 - 19 / 59 -
←
←
←
←
←
“1”
“1”
Active level
Value corresponding to the interrupt to be used
“1” (interrupt enabled)
TMPM380/M382