TMP92xy26AXBG Toshiba, TMP92xy26AXBG Datasheet - Page 366

• Manufacturer Part Number: TMP92xy26AXBG
• Manufacturer: Toshiba

Specifications of TMP92xy26AXBG

• Package: FPGA228
• Rom Types(m=mask,p=otp, F=flash,e=eeprom): Romless
• Rom Combinations: Romless
• Ram Combinations: 144/288
• Architecture: 32-bit CISC
• Usb/spi Channels: 1/1
• Uart/sio Channels: 2
• I2c/sio Bus Channels: 1
• (s)dram Controller: 1
• Adc 10-bit Channel: 6
• Da Converter: -
• Timer 8-bit Channel: 8
• Timer 16-bit Channel: 2
• Pwm 8-bit Channels: -
• Pwm 16-bit Channels: -
• Cs/wait Controller: 4
• Dual Clock: Y
• Number Of I/o Ports: 136
• Power Supply Voltage(v): 3.0 to 3.6

<TRX>
1
0
<AL>
1
0
1
0
<AAS> <AD0>
1
1
0
1
0
1
0
1/0
1/0
1/0
0
0
0
0
Table 3.15.2 Operation in the slave mode
The TMP92CF26A loses arbitration
when transmitting a slave address and
receives a slave address for which the
value of the direction bit sent from
another master is “1”.
In Salve Receiver Mode, the
TMP92CF26A receives a slave address
for which the value of the direction bit
sent from the master is “1”.
In Salve Transmitter Mode, a single
word of is transmitted.
The TMP92CF26A loses arbitration
when transmitting a slave address and
receives a slave address or GENERAL
CALL for which the value of the direction
bit sent from another master is “0”.
The TMP92CF26A loses arbitration
when transmitting a slave address or
data and terminates word data transfer.
In Slave Receiver Mode, the
TMP92CF26A receives a slave address
or GENERAL CALL for which the value
of the direction bit sent from the master
is “0”.
In Slave Receiver Mode, the
TMP92CF26A terminates receiving
word data.
92CF26A-364
Conditions
Set the number of bits a word in
<BC2:0> and write the transmitted data
to SBIDBR
Check the <LRB> setting. If <LRB> is
set to “1”, set <PIN> to “1” since the
receiver win no request the data which
follows. Then, clear <TRX> to “0” to
release the bus. If <LRB> is cleared to
“0”, set <BC2:0> to the number of bits in
a word and write the transmitted data to
SBIDBR since the receiver requests
next data.
Read the SBIDBR for setting the <PIN>
to “1” (reading dummy data) or set the
<PIN> to “1”.
Set <BC2:0> to the number of bits in a
word and read the received data from
SBIDBR.
Process
TMP92CF26A
2009-06-25