CDSCB Murata Manufacturing Co., CDSCB Datasheet - Page 103

• Manufacturer Part Number: CDSCB
• Description: Ceramic Filter For Audio/visual Equipment
• Manufacturer: Murata Manufacturing Co.

33
!Note
!Note
1. The component may be damaged if excess mechanical
2. Design layout of components on the PC board to
3. After installing chips, if solder is excessively applied to
4. When the positioning claws and pick up nozzle are worn,
5. When correcting chips with a soldering iron, the tip of the
6. Cleaning or washing of the component is not acceptable
7. In case of covering filter with over coat, conditions such
8. Accurate test circuit values are required to measure
1. Do not use this product with bend. The component
2. The component may be damaged when an excess stress
3. All kinds of re-flow soldering must not be applied
4. Do not clean or wash the component as it is not
5. Please contact Murata or Murata representative for
102
Notice (Handling)
may be damaged if excess mechanical stress is
applied to it mounted on the printed circuit board.
is applied.
on the component.
hermetically sealed.
soldering condition, in case of using lead free
CERAFILr 4.5-6.5MHz Chip Type
CERAFILr 3.5-6.5MHz Lead Type
stress is applied to it mounted on the printed circuit
board.
minimize the stress imposed on the wrap or flexure of the
board.
the circuit board, mechanical stress will cause destruction
resistance characteristics to lower. To prevent this, be
extremely careful in determining shape and dimension
before designing the circuit board diagram.
the load is applied to the chip while positioning is
concentrated to one positioning accuracy, etc. Careful
checking and maintenance are necessary to prevent
unexpected trouble.
soldering iron should not directly touch the chip
component.
due to non sealed construction.
as material of resin, cure temperature, and so on should
be evaluated carefully.
electrical characteristics. It may be a cause of
miscorrelation if there is any deviation, especially stray
capacitance, from the test circuit in the specification.
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this PDF catalog to prevent smoking and/or burning, etc.
This catalog has only typical specifications. Therefore, you are requested to approve our product specifications or to transact the approval sheet for product specificaions before ordering.
6. Do not use strong acidity flux, more than 0.2wt%
7. In case of covering filter with over coat,
8. Accurate test circuit values are required to
solder.
chlorine content, in flow soldering.
conditions such as material of resin, cure
temperature, and so on should be evaluated carefully.
measure electrical characteristics. It may be a
cause of miscorrelation if there is any
deviation, especially stray capacitance, from the
test circuit in the specification.
[Component direction]
[Component layout close to board]
Perforation
A
Slit
B
C
Susceptibility to
stress is in the order
of : A>C>B
Put the compon-
ent lateral to
the direction in
which stress
acts.
P50E.pdf 03.4.16