CDSCB Murata Manufacturing Co., CDSCB Datasheet - Page 104

• Manufacturer Part Number: CDSCB
• Description: Ceramic Filter For Audio/visual Equipment
• Manufacturer: Murata Manufacturing Co.

!Note
!Note
1. The component may be damaged if excess mechanical
2. Design layout of components on the PC board to
3. After installing chips, if solder is excessively applied to
1. The component will be damaged when an excessive
2. Use coupling capacitors to prevent applying D.C.
3. In the case that the component is cleaned, confirm
4. In case of covering filter with over coat,
1. Do not use this product with bend. The component
2. The component will be damaged when an excessive
3. All kinds of re-flow soldering must not be applied
4. Do not clean or wash the component as it is not
5. Do not use strong acidity flux, more than 0.2wt%
stress is applied.
voltage between input-ground, output-ground of
"CERAFIL" as D.C. current may harm the component.
that no reliability degradation is created.
conditions such as material of resin, cure
temperature, and so on should be evaluated carefully.
may be damaged if excess mechanical stress is
applied to it mounted on the printed circuit board.
stress is applied.
on the component.
hermetically sealed.
chlorine content, in flow soldering.
CERAFILr 455kHz Chip Type PFWCC Series
CERAFILr 455kHz Chip Type SFPCA Series
CERAFILr 455kHz Lead Type
stress is applied to it mounted on the printed circuit
board.
minimize the stress imposed on the warp or flexure of the
board.
the circuit board, mechanical stress will cause
destruction resistance characteristics to lower. To
prevent this, be extremly careful in determining shape
and dimension before designing the circuit board
diagram.
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this PDF catalog to prevent smoking and/or burning, etc.
This catalog has only typical specifications. Therefore, you are requested to approve our product specifications or to transact the approval sheet for product specificaions before ordering.
5. Do not use strong acidity flux, more than 0.2wt%
6. The product, packed in the moisture-proof bag
6. In case of covering filter with over coat,
7. Accurate test circuit values are required to
8. Use coupling capacitors to prevent applying D.C.
chlorine content, in re-flow soldering.
(dry pack), is sensitive to moisture. The following
treatment is required before applying re-flow
soldering, to avoid package cracks or reliability
degradation caused by thermal stress. When unpacked,
store the component in an atmosphere of below 25
degree C and below 65% R.H., and solder within 48
hours.
conditions such as material of resin, cure
temperature, and so on should be evaluated carefully.
measure electrical characteristics.
It may be a cause of miscorrelation if there is
any deviation, especially stray capacitance, from
the test circuit in the specification.
voltage between input-ground, output-ground of
"CERAFIL" as D.C. current may harm the component.
[Component direction]
[Component layout close to board]
Perforation
A
Slit
B
C
Notice (Handling)
Susceptibility to
stress is in the order
of : A>C>B
Put the
component
lateral to the
direction in
which stress
acts.
P50E.pdf 03.4.16
103
33