CDSCB Murata Manufacturing Co., CDSCB Datasheet - Page 106

• Manufacturer Part Number: CDSCB
• Description: Ceramic Filter For Audio/visual Equipment
• Manufacturer: Murata Manufacturing Co.

!Note
!Note
1. The component mounted on the PCB may be damaged if
2. Layout the components on the PCB to minimize the
3. After installing components, if solder is excessively
4. When the positioning claw or pick up nozzle are worn, the
5. When correcting component's position with a soldering
6. Do not clean or wash the component as it is not
7. In case of overcoating the part, coating conditions such
8. Accurate test circuit values are required to measure
1. Do not use this product with bend. The component
2. The component may be damaged when an excess stress
3. All kinds of re-flow soldering must not be applied
4. Do not clean or wash the component as it is not
5. Do not use strong acidity flux, more than 0.2wt%
may be damaged if excess mechanical stress is
applied to it mounted on the printed circuit board.
is applied.
on the component.
hermetically sealed.
Ceramic Discriminator 10.7MHz Chip Type
Ceramic Discriminator 10.7MHz Lead Type
excess mechanical stress is applied.
stress imposed by the warp or flexure of the board.
applied to the circuit board, mechanical stress will cause
destruction resistance characteristics to be lower. To
prevent this, be extremely careful in determining shape
and dimension before designing the circuit board diagram.
excess load is applied to the components while
positioning or placing are performed. Careful checking
and maintenance are necessary to prevent unexpected
trouble.
iron, the tip of the soldering iron should not directly touch
the chip component. Depending on the soldering
conditions, the effective area of terminations may be
reduced. The use of solder containing Ag should be
considerd to prevent the electrode erosion.
hermetically sealed.
as material, curing temperature, and so on must be
evaluated deeply.
electrical characteristics.
It may be a cause of miscorrelation if there is any
deviation, especially stray capacitance, from the test
circuit in the specification.
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this PDF catalog to prevent smoking and/or burning, etc.
This catalog has only typical specifications. Therefore, you are requested to approve our product specifications or to transact the approval sheet for product specificaions before ordering.
6. In case of covering discriminator with over coat,
7. Accurate test circuit values are required to
chlorine content, in flow soldering.
conditions such as material of resin, cure
temperature, and so on should be evaluated carefully.
measure electrical characteristics. It may be a
cause of miscorrelation if there is any deviation,
especially stray capacitance, from the test
circuit in the specification.
[Component direction]
[Component layout close to board]
Perforation
A
Slit
B
C
Notice (Handling)
Susceptibility to
stress is in the order
of : A>C>B
Put the
component
laterally to the
direction in
which stress
acts.
P50E.pdf 03.4.16
105
33