MAX8686 Maxim Integrated Products, MAX8686 Datasheet - Page 8
![no-image](/images/manufacturer_photos/0/4/417/maxim_integrated_products_sml.jpg)
MAX8686
Manufacturer Part Number
MAX8686
Description
DC-DC Converter Delivers Up To 25A Per Phase
Manufacturer
Maxim Integrated Products
Datasheet
1.MAX8686.pdf
(22 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
MAX8686ETL+T
Manufacturer:
MAIXM
Quantity:
3 636
www.DataSheet4U.com
Single/Multiphase, Step-Down,
DC-DC Converter Delivers Up to 25A Per Phase
8
18–26
_______________________________________________________________________________________
5, 16
7–15
PIN
17
27
28
29
30
31
32
1
2
3
4
6
EN/SLOPE
GFREQ
NAME
PGND
GND
POK
CS+
RTN
N.C.
AVL
BST
CS-
INA
LX
VL
IN
Negative Differential Current-Sense Input. Connect CS- to the output side of the inductor for lossless
current sense or to the load side of the current-sense resistor.
Positive Differential Current-Sense Input. Connect CS+ to the inductor through an RC network for
lossless current sense or to the inductor side of the current-sense resistor.
C
as possible to the device.
Enable and Slope Compensation Input. Connect a resistor from EN/SLOPE to GND to set the desired
slope compensation ramp voltage. An internal 10µA current source pulls up EN/SLOPE. The device
shuts down when the voltage at EN/SLOPE is less than 0.7V. Connect EN/SLOPE to an open-drain or
open-collector output for system enable or phase-shedding function.
Inductor Connection. LX is high impedance during shutdown.
Power Ground for Low-Side Gate Driver. Connect RTN to PGND plane at the return terminal of the IN
bypass capacitor.
Power Ground. Low-side MOSFET source connection.
No Connection. Not internally connected.
Power Input. Connect IN to the input voltage source. Connect input bypass capacitor from IN to PGND
as close as possible to the device. Connect IN, INA, and VL together for 5V operation (see Figure 3).
Input of the Internal VL Linear Regulator. Bypass INA with a 0.1µF capacitor to PGND.
Analog Ground
Input Voltage to the Device’s Internal Analog Circuitry. Connect AVL to VL through a lowpass RC filter.
Internal 5.4V Linear Regulator Output. Connect a ceramic capacitor of at least 1µF from VL to RTN. INA
is the input to this linear regulator. Connect VL to INA when V
for the MOSFET drivers.
Boost Capacitor Connection. Connect a 0.22µF ceramic capacitor from BST to LX.
Power-Good Output. POK is an open-drain output that is high impedance when the output voltage is at
its nominal regulated voltage. The POK rising threshold is 90% of the reference voltage at REFIN. POK
is internally pulled low during shutdown. Connect POK to GND for slave mode operation.
FREQ
Capacitor Return Terminal. Connect the frequency-setting capacitor C
FUNCTION
INA
is less than 5.5V. VL provides power
Pin Description
FREQ
to GFREQ as close