cy2277a Cypress Semiconductor Corporation., cy2277a Datasheet - Page 16

• Manufacturer Part Number: cy2277a
• Description: 6x86, K6 Clock Synthesizer/driver For Desktop Mobile Pcs With Intel 82430tx And 2 Dimms Or 3 So-dimms Semiconductor
• Manufacturer: Cypress Semiconductor Corporation.

Application Circuit
Application Information
Clock traces must be terminated with either series or parallel termination, as is normally done.
Document #: 38-07332 Rev. *A
Summary
• A parallel-resonant crystal should be used as the reference to the clock generator. The operating frequency and C
• Surface mount, low-ESR, ceramic capacitors should be used for filtering. Typically, these capacitors have a value of 0.1 F.
• The value of the series terminating resistor satisfies the following equation, where R
• Footprints must be laid out for optional EMI-reducing capacitors, which should be placed as close to the terminating resistor
• A Ferrite Bead may be used to isolate the Board V
• If a Ferrite Bead is used, a 10 F– 22 F tantalum bypass capacitor should be placed close to the Ferrite Bead. This capacitor
this crystal should be as specified in the data sheet. Optional trimming capacitors may be needed if a crystal with a different
C
In some cases, smaller value capacitors may be required.
of the trace, R
resistor.
as is physically possible. Typical values of these capacitors range from 4.7 pF to 22 pF.
greater than 50 impedance at the clock frequency, under loaded DC conditions. Please refer to the application note “Layout
and Termination Techniques for Cypress Clock Generators” for more details.
prevents power supply droop during current surges.
LOAD
is used. Footprints can be laid out for flexibility.
R
series
out
is the output impedance of the clock generator (specified in the data sheet), and R
> R
trace
– R
out
DD
from the clock generator V
DD
trace
island. Ensure that the Ferrite Bead offers
is the loaded characteristic impedance
series
is the series terminating
CY2277A
Page 16 of 19
LOAD
of