pca9670 NXP Semiconductors, pca9670 Datasheet - Page 8
![no-image](/images/manufacturer_photos/0/4/487/nxp_semiconductors_sml.jpg)
pca9670
Manufacturer Part Number
pca9670
Description
Pca9670 Remote 8-bit I/o Expander For Fm I?c-bus With Reset
Manufacturer
NXP Semiconductors
Datasheet
1.PCA9670.pdf
(28 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
pca9670D
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
pca9670D,512
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Company:
Part Number:
pca9670PW
Manufacturer:
NXP Semiconductors
Quantity:
1 788
Company:
Part Number:
pca9670PWЈ¬118
Manufacturer:
NXP
Quantity:
35
NXP Semiconductors
PCA9670_2
Product data sheet
7.2.1 Software Reset
7.2 Software Reset Call, and device ID addresses
Two other different addresses can be sent to the PCA9670.
The Software Reset Call allows all the devices in the I
state value through a specific formatted I
implies that the I
The Software Reset sequence is defined as following:
1. A START command is sent by the I
2. The reserved General Call I
3. The PCA9670 device(s) acknowledge(s) after seeing the General Call address
4. Once the General Call address has been sent and acknowledged, the master sends
5. Once the right byte has been sent and correctly acknowledged, the master sends a
Fig 7. General Call address
Fig 8. Device ID address
•
•
General Call address: allows to reset the PCA9670 through the I
reception of the right I
information.
Device ID address: allows to read ID information from the device (manufacturer, part
identification, revision). See
information.
is sent by the I
‘0000 0000’ (00h) only. If the R/W bit is set to 1 (read), no acknowledge is returned to
the I
1 byte. The value of the byte must be equal to 06h.
a. The PCA9670 acknowledges this value only. If the byte is not equal to 06h, the
If more than 1 byte of data is sent, the PCA9670 does not acknowledge any more.
STOP command to end the Software Reset sequence: the PCA9670 then resets to
the default value (power-up value) and is ready to be addressed again within the
specified bus free time. If the master sends a Repeated START instead, no reset is
performed.
PCA9670 does not acknowledge it.
2
C-bus master.
2
C-bus is functional and that there is no device hanging the bus.
2
C-bus master.
Rev. 02 — 17 July 2007
2
C-bus sequence. See
0
1
2
Section 7.2.2 “Device ID (PCA9670 ID field)”
C-bus address ‘0000 000’ with the R/W bit set to 0 (write)
Remote 8-bit I/O expander for Fm+ I
0
1
0
1
2
C-bus master.
2
C-bus command. To be performed correctly, it
0
1
0
1
Section 7.2.1 “Software Reset”
0
0
002aac115
002aac116
2
0
0
C-bus to be reset to the power-up
R/W
R/W
0
2
C-bus upon
PCA9670
© NXP B.V. 2007. All rights reserved.
2
C-bus with reset
for more
for more
8 of 28