at91rm3400 ATMEL Corporation, at91rm3400 Datasheet - Page 103

no-image

at91rm3400

Manufacturer Part Number
at91rm3400
Description
Atmel Advanced At91 Arm Microcontroller
Manufacturer
ATMEL Corporation
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
at91rm3400-AU-002
Manufacturer:
Atmel
Quantity:
10 000
I/O Line
Description
Product Dependencies
I/O Lines
Power
Management
Interrupt Sources
1790A–ATARM–11/03
Table 28. I/O Line Description
The interrupt signals FIQ and IRQ0 to IRQn are normally multiplexed through the PIO control-
lers. Depending on the features of the PIO controller used in the product, the pins must be
programmed in accordance with their assigned interrupt function. This is not applicable when
the PIO controller used in the product is transparent on the input path.
The Advanced Interrupt Controller is continuously clocked. The Power Management Controller
has no effect on the Advanced Interrupt Controller behavior.
The assertion of the Advanced Interrupt Controller outputs, either nIRQ or nFIQ, wakes up the
ARM processor while it is in Idle Mode. The General Interrupt Mask feature enables the AIC to
wake up the processor without asserting the interrupt line of the processor, thus providing syn-
chronization of the processor on an event.
The Interrupt Source 0 is always located at FIQ. If the product does not feature an FIQ pin, the
Interrupt Source 0 cannot be used.
The Interrupt Source 1 is always located at System Interrupt. This is the result of the OR-wir-
ing of the system peripheral interrupt lines, such as the System Timer, the Real Time Clock,
the Power Management Controller and the Memory Controller. When a system interrupt
occurs, the service routine must first distinguish the cause of the interrupt. This is performed
by reading successively the status registers of the above mentioned system peripherals.
The interrupt sources 2 to 31 can either be connected to the interrupt outputs of an embedded
user peripheral or to external interrupt lines. The external interrupt lines can be connected
directly, or through the PIO Controller.
The PIO Controllers are considered as user peripherals in the scope of interrupt handling.
Accordingly, the PIO Controller interrupt lines are connected to the Interrupt Sources 2 to 31.
The peripheral identification defined at the product level corresponds to the interrupt source
number (as well as the bit number controlling the clock of the peripheral). Consequently, to
simplify the description of the functional operations and the user interface, the interrupt
sources are named FIQ, SYS, and PID2 to PID31.
Pin Name
FIQ
IRQ0 - IRQn
Pin Description
Fast Interrupt
Interrupt 0 - Interrupt n
AT91RM3400
Type
Input
Input
103

Related parts for at91rm3400